Use and Care Manual

Operator's Manual
Breez™ R2 Propane Powered Tiller
Check for parts online at www.breezpropanetillers.com or call 800-345-6007 M-F 8-5
10
UNPACKING AND ASSEMBLY
Unpack Tiller
1. Carefully lift the tiller out of the box, remove any packing
material and cut any ties holding the handlebar pieces or
tines to the tiller assembly.
2. Find parts packet. Parts packet contains:
• 4 - T-Handle Nuts (4640)
• 4 - Curved Washers (4641)
• 4 - Handle Clamp Bolts (4642)
3. Find manual packet. Manual packet contains:
• 1 - Hair Pin (4652)
Assembly
1. Stand the tiller assembly upright with tines and wheels
on a level surface. DO NOT place the tiller on a high
surface where it can fall and cause property damage or
personal injury.
2. Slide inside tine B onto tine shaft.
3. Slide outside tine A onto end of tine shaft next.
4. Insert hair pin into hole at end of tine shaft to lock the
tines in place.
2. Using two T-handle nuts, two handlebar clamp bolts, and
two curved washers, attach the middle handlebars to the
lower handlebar that is already connected to the tiller
assembly. The middle handlebars can be installed in one
of two positions, one high and one low. SEE FIGURE 1
DO NOT overtighten the T-handle nuts.
3. Attach the upper handlebar to the middle handlebars
using the two remaining T-handle nuts, handle clamp
bolts, and curved washers. SEE FIGURE 1. DO NOT
overtighten the T-handle nuts.
WARNING
DO NOT STORE ENGINE INDOORS WITH FUEL
CYLINDER ATTACHED. FUEL AND FUEL VAPORS
ARE HIGHLY FLAMMABLE.
NEVER REFILL FUEL CYLINDERS. USE ONLY
METAL, DISPOSABLE PROPANE FUEL CYLINDERS
APPROVED BY THE UNDERWRITER’S LABORATORY
U.L. OR THE AMERICAN SOCIETY FOR TESTING &
MATERIALS ASTM.
AN ADULT MUST ALWAYS HANDLE AND REPLACE
THE FUEL CYLINDER.
ALWAYS HANDLE PROPANE IN A WELL
VENTILATED AREA, OUTDOORS, AWAY FROM
FLAMES OR SPARKS.
NEVER RUN ENGINE INDOORS. EXHAUST FUMES
ARE DEADLY.
FAILURE TO FOLLOW THESE WARNINGS CAN
CAUSE DAMAGE TO EQUIPMENT AND INJURY TO
PERSONNEL.
UPPER
HANDLEBAR
HANDLEBAR
CLAMP BOLT
MIDDLE LEFT
HANDLEBAR
LOWER
HANDLEBAR
MIDDLE RIGHT
HANDLEBAR
T-HANDLE
NUT
CURVED
WASHER
OPERATION
PROPANE AND OIL
NOTE: Engine is shipped from factory without oil. You
must add engine oil before starting engine. If
engine is started without oil, engine may be
damaged beyond repair and will not be covered
by warranty.
Oil Quality
To operate the engine, we recommend using “VIPER®” brand
4-cycle oil (13235), included with each new Breez™ R2, or
an equivalent 10W-30 engine oil to ensure that the engine
operates correctly throughout the life of the engine. Use 16.4
oz (465 gram) disposable propane fuel cylinders.
Checking and Adding Oil
Be sure the engine is located on a level surface before
checking or relling oil. Proper position for checking oil level
or relling oil is face down on the wheel mount cover. It is
recommended to remove the wheels in order to ensure a level
surface. SEE FIGURE 2A
IMPORTANT
ENGINE MUST BE TIPPED FORWARD WHEN CHECKING
OIL LEVEL OR FILLING WITH OIL. FAILURE TO DO SO
CAN RESULT IN OVERFILLING THE ENGINE WITH OIL
WHICH WILL IMPAIR THE ENGINE’S PERFORMANCE.
FIGURE 1