Use and Care Manual

Operator's Manual
Breez™ R2 Propane Powered Tiller
Check for parts online at www.breezpropanetillers.com or call 800-345-6007 M-F 8-5
14
WARNING
NEVER STORE TILLER WITH FUEL CYLINDER
ATTACHED INSIDE AN ENCLOSED AREA OR
BUILDING. FUEL VAPORS CAN COLLECT AND
CAUSE A FIRE.
CAUTION
DO NOT TWIST AIR FILTERS WHEN CLEANING. ALWAYS
PRESS. TWISTING OR TOO MUCH FORCE CAN DAMAGE THE
FILTER ELEMENT.
Transporting Your Tiller
1. After using the tiller and before transporting it, remove
the fuel cylinder from the bottle holder.
2. Disconnect the fuel cylinder from the regulator hose and
and cover with safety cap to prevent damage to the valve
seals.
Long-Term Storage
1. Remove the fuel cylinder from the bottle holder.
2. Disconnect the fuel cylinder from the regulator hose and
and cover with safety cap to prevent damage to the valve
seals.
3. Store tiller in the upright position. SEE FIGURE 6
4. Remove all debris from tiller tines and engine.
BACK LATCH TABS
AIR FILTER COVER
FRONT
LATCH
TAB
COVER
BOLT
AIR FILTER
COVER
FOAM FILTER
ELEMENT
FIBER FILTER
ELEMENT
FIGURE 4
FIGURE 5
FIGURE 6
TROUBLESHOOTING AND REPAIR
At Breez™, we build quality and durability into the design
of our products; but no amount of careful design by us, and
careful maintenance by you, can guarantee a repair-free life for
your Breez™ Tiller. Most repairs will be minor, and easily xed
by following the suggestions in the troubleshooting guide in
this section.
The guide will help you pinpoint the causes of common
problems and identify remedies.
Step for Replacing and Cleaning Air Filter:
1. To remove air lter cover, unscrew the cover bolt with a
screw driver and gently pop out the front latch tab. The
cover then can be slid o the back latch tabs and away
from the engine. SEE FIGURE 4
2. Remove the foam lter and ber lter elements. Replace
with a new ber lter and a new oiled foam lter
(SEE FIGURE 5), or clean the original foam and ber
lters with warm water and mild soap. Remember to
thoroughly oil the foam lter with 30 or 40 weight motor
oil and squeeze out any excess oil before reinstalling it.
Make sure to press the foam lter evenly into place over
the ber lter to ensure that the foam is fully seated into
its sealed position.
3. Replace the air lter cover by rst connecting the back
latch tabs then swinging the cover, making sure the foam
lter block stays fully seated and in its proper position,
and connect the front latch tab so that it is secured into
place.
4. Screw the cover bolt back into place. Check that the
cover is securely attached by pulling slightly on the cover.
If the cover doesn’t move when pulled, it is secure.