Use and Care Manual

Operator's Manual
Breez™ R2 Propane Powered Tiller
Check for parts online at www.breezpropanetillers.com or call 800-345-6007 M-F 8-5
21
15073 BORDEREDGER KIT INSTALLATION OPTIONAL ACCESSORY
KEY # PART # DESCRIPTION QTY.
1 15009 BORDEREDGER TINE 1
2 46131 BORDEREDGER WHEEL 1
3 46134 HAIRPIN 1
PARTS BREAKDOWN
The Border-Edger Kit is a useful tool for making clean cuts in
the lawn along the borders of gardens, ower beds, walkways,
and driveways for a well manicured look. To install the Border-
Edger Kit, do the following:
INSTALLATION
1. Make sure the tiller is not running by ipping the ON/OFF
switch to the OFF position.
2. Remove the hairpins from both sides of the tine shaft.
3. Remove the tilling tines from the shaft, remembering which
direction they are facing.
4. Put the tines in a safe place and save the (2) hairpins, they will
be used on the Border-Edger Kit.
5. Slide the border-edger tine onto either side of the tine
shaft. Make sure that the hub collar of the border-edger
tine faces outward, away from the transmission of the tiller.
SEE FIGURE 7
6. Take the (2) hairpins saved in Step 4 and insert them through
the inner and outer holes in the tine shaft on each side of the
border-edger tine to secure the tine blade in place on the
shaft. SEE FIGURE 7
7. Slide the border-edger wheel onto the opposite side of the
tine shaft as far as it will go.
8. Insert the remaining (1) hairpin, that came with the kit,
through the inner hole next to the wheel in the middle of the
tine shaft. SEE FIGURE 7
NOTE: Never use the Border-Edger Kit with the drag stake
installed.
CAUTION
BE AWARE THAT THE TILLER COULD UNEXPECTEDLY
BOUNCE UPWARD, OR JUMP FORWARD IF THE TINES
STRIKE CONCRETE, PAVEMENT, OR OTHER HARD
SURFACES OR HARD OBSTACLES BURIED UNDER
GROUND.
BORDER-EDGER WHEEL
TINE SHAFT
BORDER-EDGER
TINE
HAIRPIN
HUB
COLLAR
KIT ASSEMBLED
FIGURE 7