Operation Manual

BATTERIES
If the batteries are installed when the
display is completely blank, the
display will remain blank for 5
seconds. After 5 seconds the display
will show “Id” for 1 second, then
display the clock. The remote control
is now ready to use.
The remote control requires 3 AAA
batteries. The use of good quality
alkaline batteries is recommended.
Under normal conditions a set of
batteries will operate for 18 months.
When the batteries are getting low on
power, BATTERY LOW is displayed
on the screen (the cooler may also
switch off while the display remains
ON). This indicates that the batteries
have only a small amount of life
remaining.
To change the batteries remove the
cover from the back of the remote
control. Pull out the old batteries and
replace them all with the new ones.
Do not mix new batteries with old
batteries.
The remote control has 2 minutes of
back-up power to retain its memory
while the batteries are being changed.
Do not use rechargeable batteries as
their voltage rating is too low for the
remote control.
DIP SWITCHES
WARNING: Do not alter DIP
switches 1 to 10 as the cooler
will cease to work.
There are 2 rows of DIP switches
located under the battery cover on
the remote control.
Definition of DIP switch positions
(first 6 in bottom row only) are as
follows:
(A). Reserved for later use.
(B). OFF, 24 hour clock.
ON, 12 hour clock.
(C). OFF, 1100 / 1500W motor.
ON, 380 / 550 / 750W motor.
(D). OFF, no pre-cool.
ON, pre-cool.
(E). OFF, drains 3 days after
power off.
ON, drains 3 hours after
power off.
(F). OFF, drains every 65 minutes
of operation.
ON, activates water salinity
circuit (WaterManager ).
®
ILL217-G
ON
ON
1 2 3 4 5 6 7 8
A B C D E F 9 10
OFF
OFF
EXAMPLE ONLY
AUTO COOL
PM
FAN
SPEED
BATTERY LOW
ILL1106-A
®
10
Evaporative Cooler
TURNING THE COOLER ON
PREPARING TO START
MANUAL MODE
The wall control can be switched
on and off by pressing the
button. The wall control will
remember the previous setting it
was in when the cooler was last
used.
With the wall control switched
ON, press the button
until MAN is shown on the
display.
You may then press the
button to switch between COOL
and VENT (where fresh air is
being delivered but not cooled).
Whenever you select AUTO
mode or COOL in MANUAL
mode, the cooler will take a few
minutes to start as it fills with
water and saturates the cooling
pads. The time will be decreased
if the tank is full or the cooler has
only recently been turned OFF.
During this time PREPARING TO
START will flash on the display.
ILL1122-B
Once COOL or VENT has been
selected, the wall control will maintain
a constant fan speed. This is indicated
by the bar graph shown on the display.
In AUTO mode the cooler will
remember the last setting used and try
to achieve this. It may vary depending
on the day’s conditions. Press the
button if you require more cool
air or the button if you require
less. Don’t alter the setting however,
until the room temperature has
stabilised.
To increase or decrease the fan speed
required, press either the or
button.
To select the AUTO mode press the
button until AUTO is shown on
the display.
AUTO MODE
ILL1124-B
ILL1123-B
SEELEY INTERNATIONAL – OWNER’S MANUAL 11