Installation Sheet

ManualsBrandsBreezaire ManualsAppliancesWine Cellar Cooling System - 140 Cu. Ft

Table Of Contents

8610 Production Avenue  San Diego, California 92121  (858) 566-7465  Fax (858) 566-1943

BREEZAIRE Products Company - 8610 Production Avenue - San Diego, CA USA 92121 - (858) 566-7465

WKL SERIES

(USA ONLY)

--INSTALLATION INSTRUCTIONS--

Thank you for choosing a BREEZAIRE cooling unit. We believe our products are

the best on the market and will provide many years of trouble-free service.

Please take a few minutes and read this entire instruction before beginning the

installation.

MODEL _____________________ SERIAL NUMBER ______________________

INSTALLED BY ______________________________ DATE__________________

While great effort has been made to provide accurate guidelines, BREEZAIRE cannot warrant its units to properly cool

a particular enclosure. Customers are cautioned that enclosure construction, unit location and many other factors can affect

the operation and performance of the unit. Therefore the suitability of the unit for a specific enclosure or application must be

determined by the customer and cannot be warranted by BREEZAIRE.

Before removing the cooling unit from the box, please inspect for damage, which might have

occurred during shipping. If damage is found, notify the Freight Company immediately.

BREEZAIRE is not responsible for any damages during shipping.

Summary of content (5 pages)

PAGE 1
8610 Production Avenue  San Diego, California 92121  (858) 566-7465  Fax (858) 566-1943 WKL SERIES (USA ONLY) --INSTALLATION INSTRUCTIONS-- Thank you for choosing a BREEZAIRE cooling unit. We believe our products are the best on the market and will provide many years of trouble-free service. Please take a few minutes and read this entire instruction before beginning the installation. Before removing the cooling unit from the box, please inspect for damage, which might have occurred during shipping.
PAGE 2
INSTALLATION INSTRUCTIONS FOR WKL SERIES COOLING UNITS The BREEZAIRE WKL Series cooling units are designed to, when installed in a properly constructed enclosure, provide a constant, selectable temperature between approximately 48°F and 63°F while reducing the excess relative humidity to the proper 50% to 75%. BREEZAIRE cooling units are designed to lower the temperature, while removing only excessive moisture. In a properly constructed enclosure this process can raise the relative humidity.
PAGE 3
Top brace Ceiling 6" Min. Warm Air Exhaust (Condenser) Grill Molding WK(L) Cooling Unit Seal H* MINIMUM CLEARANCE 3 FEET Wine Room Evaporator Side W* Warm Air Exhaust (Condenser Side) Studs Shelf Brace *See Specifications Drain Line (if required) Figure 3 Figure 2 BREEZAIRE units should NOT be installed in a fire rated wall without consulting your local building inspector and building codes. If your installation cannot be performed in accordance with these instructions contact your dealer.
PAGE 4
Operation On initial start-up the cooling unit will reduce the temperature of the enclosure slowly. The unit may run constantly or cycle off for short periods. The time required to reach the desired temperature will vary, depending on the enclosure construction and contents. The Sentry III is factory set to approximately 55°Fahrenheit. Unless the temperature falls below that which is desired, do not change the thermostat setting for at least 3 days.
PAGE 5
temperature and/or water overflows from the unit. One way of discovering gross air leaks is to stand inside the enclosure with the lights off, allow your eyes to adapt to the dark and look for light showing through cracks in the walls or around the door. Also close the door on a piece of paper, if you can pull the paper through the door seal, it means air and moisture are also entering into your enclosure.