Operation Manual

4. Wait until the display switches off and put the equipment in motion to apply the

changes.

Cleaning and maintenance

The equipment does not require special maintenance. The equipment does not

require recalibration when it is assembled, used and serviced according to the

instructions.

WARNING

– Before cleaning and maintenance, remove the adapter.

– Do not use solvents to clean the equipment.

▪ Clean the equipment with a soft, absorbent cloth after each use.

▪ Regularly check that all screws and nuts are tight.

▪ If necessary, lubricate the joints.

Generator

The equipment is equipped with a generator. You do not need to plug in an adapter,

but generate your own power by operating the equipment. A back-up battery pack

supports the generator to keep the console activated if the equipment is operated

very slowly or not at all. The display will remain on for 90 seconds.

If the RPM is more than 45, the battery pack will be recharged. If the battery pack is

empty, use the supplied adapter (6V, 500 mA) to recharge the battery pack. To save

battery lifetime, the maximum charging time is 6 hours. If the battery pack must be

replaced, contact your dealer for a replacement battery pack.

Replacing the battery pack

1. Locate the battery pack compartment on the underside of the equipment.

2. Remove the cover.

3. Remove the old battery pack.

4. Insert the new battery pack.

5. Mount the cover.

CF7 27