user manual

Ref Qty Part# Description

AA 4 015-0045 Floor Glides

BB 16 030-0325 1/4-20 x 1/2” Truss Screws

CC 12 030-0207 1/4-20 Flanged Hex Nuts

DD 4 030-0313-901 Machine Rest Cups

EE 4 030-0272 1/4-20 x 1/2” Carriage Bolts

FF 4 030-0274 Lock Washers

GG 4 030-0006 1/4-20 Wing Nuts

1 018-0034 13” Ground Wire

HARDWARE LIST

STEP 1

Twist on the floor glides (AA) onto

the bottom of both pedestals.

Lay one pedestal on a flat surface with holes facing

upward. Position modesty panel on pedestal panel and

attach with screws (BB). Position other pedestal on

modesty panel and attach with screws. Stand unit upright.

STEP 2

PARTS LIST

Qty Part# Description

2 010-1627 Machine Rests

4 010-1629 Extender Brackets

1 010-1630 Modesty Panel

1 014-0166 Wire Basket

1 022-1324 Right Pedestal Assembly

1 022-1325 Left Pedestal Assembly

TOOLS REQUIRED

Phillips Screwdriver

Adjustable Wrench

Assembly Instructions

PRINTER STAND

UNI1

PAGE 1
UNI1 PRINTER STAND Assembly Instructions PARTS LIST Qty 2 4 1 1 1 1 Part# 010-1627 010-1629 010-1630 014-0166 022-1324 022-1325 Description Machine Rests Extender Brackets Modesty Panel Wire Basket Right Pedestal Assembly Left Pedestal Assembly TOOLS REQUIRED HARDWARE LIST Ref AA BB CC DD EE FF GG Qty 4 16 12 4 4 4 4 1 Part# 015-0045 030-0325 030-0207 030-0313-901 030-0272 030-0274 030-0006 018-0034 Description Floor Glides 1/4-20 x 1/2” Truss Screws 1/4-20 Flanged Hex Nuts Machine Rest Cups 1/4-20 x
PAGE 2
STEP 3 STEP 4 Attach machine rests between pedestals using screws (BB) and flange nuts (CC) as shown. The spacing of the machine rests is determined by your printer size. If printer is larger than printer stand, use the extender brackets to give you additional length. Place extender brackets on machine rests and fasten with screws (BB) and flange nuts (CC) as shown. Slide extender brackets out to desired size. CC STEP 5 STEP 6 Hook wire basket into the slots on the back of the unit.