the Duo-Temp™ Pro Instruction Booklet Suits all BES810 models BES810BSS_ANZ_IB_E14.
CONGRATULATIONS on the purchase of your new Breville product BES810BSS_ANZ_IB_E14.
Contents 4 Breville recommends safety first 8 Know your Breville product 12 Operating your Breville product 17 Coffee making tips & preparation 22 Care & cleaning 26 Troubleshooting 31 Coffees to try 3 BES810BSS_ANZ_IB_E14.
Breville recommends safety first At Breville we are very safety conscious. We design and manufacture consumer products with the safety of you, our valued customer, foremost in mind. In addition we ask that you exercise a degree of care when using any electrical appliance and adhere to the following precautions. Important safeguards Read all instructions BEFORE USE AND SAVE FOR FUTURE REFERENCE • Do not use the Breville Duo-Temp™ Pro on a sink drain board.
Breville recommends safety first • Use only cold, tap water in the water tank. Do no use any other liquid. • Never use the Breville Duo-Temp™ Pro without water in the water tank. • Ensure the portafilter is firmly inserted and secured into the Group Head before using the machine. • Never remove the portafilter during the extraction as the machine is under pressure. • Do not move the Breville Duo-Temp™ Pro whilst in operation.
Breville recommends safety first IMPORTANT SAFEGUARDS FOR ALL ELECTRICAL APPLIANCES • Unwind the power cord fully before use. • Do not let the power cord hang over the edge of a bench or table, touch hot surfaces, or become knotted. • To protect against electric shock do not immerse power cord, power plug or appliance in water or any other substance.
Breville recommends safety first • This appliance is recommended for household use only. Do not use this appliance for anything other than its intended use. Do not use in moving vehicles or boats. Do not use outdoors. Misuse may cause injury. • The installation of a residual current device (safety switch) is recommended to provide additional safety protection when using electrical appliances.
KNOW your Breville product BES810BSS_ANZ_IB_E14.
FEATURES OF YOUR breville product PID Temperature Control Low Pressure Pre-infusion Electronic PID temperature control for increased temperature stability. Applies low pressure at the start of the extraction to gently expand grinds for an even extraction. Auto Purge Automatically adjusts water temperature after steam for optimal coffee temperature. Thermocoil Heating System Integrated stainless steel water coil accurately controls water temperature.
Know your breville product I A J B K C D E L F G H 10 BES810BSS_ANZ_IB_E14.
Know your breville product A. POWER button surround illuminates when machine is switched on. B. Thermocoil heating system accurately controls water temperature. C. Integrated removable tamper for NOT SHOWN • Removable 1.8L water tank filled from the top with integrated water filtration. • Storage tray located behind the drip tray for storage of accessories. tamping control. D. Group head for easy positioning of the portafilter. E. 54mm stainless steel portafilter with commercial style spouts. F.
OPERATING your Breville product BES810BSS_ANZ_IB_E14.
Operating your BREVILLE PRODUCT Before First Use FIRST USE Machine Preparation Remove and discard all labelling and packaging materials attached to your espresso machine. Ensure you have removed all parts and accessories before discarding the packaging. Clean parts and accessories (water tank, portafilter, filter baskets and jug) using warm water and a gentle dish washing liquid and rinse well. Wipe the outer housing and drip tray with a soft damp cloth and dry thoroughly.
Operating your BREVILLE PRODUCT Filling the Water Tank • Ensure the water filter is securely fitted inside the tank. Fill the water tank with cold tap water to the maximum mark on the side of the tank and slide the water tank back into position at the back of the machine. Plug the power cord into power outlet and switch On at power point. Press the POWER button. The POWER button surround will flash while the machine is heating.
Operating your BREVILLE PRODUCT Extracting Espresso Low Pressure Pre-Infusion Insert the Portafilter into the Group Head & lock into position. Turn the Control Dial to the ‘Espresso’ position. A pumping noise will be heard. After a few seconds, coffee will begin to brew into the cup. The low pressure pre-infusion gradually increases water pressure to gently expand grinds for an even extraction before increasing to full pressure.
Operating your BREVILLE PRODUCT texturing milk Hot Water The Duo Temp™ Pro is equipped with a commercial style steam wand. The machine features a separate Hot Water function that dispenses hot water from the Steam Wand. • Before inserting the steam wand into the milk, it is recommended to purge the steam wand. Turn the Control Dial to ‘Steam’. • To use the Hot Water function: • Press the ‘SELECT’ button and the Hot Water LED will illuminate. • Direct the spout outlet towards the drip tray.
COFFEE MAKING TIPS & PREPARATION 17 BES810BSS_ANZ_IB_E14.
Coffee Making Tips & Preparation PRE-HEATING Advanced Dual Wall Filter Baskets A warm cup will help maintain the coffee’s optimal temperature. Preheat your cup by rinsing with hot water and place on the cup warming tray. The Dual Wall filters (1 & 2 CUP) are designed to be used with pre-ground coffee and regulate the pressure to help optimise extraction and crema regardless of the grind, dose or tamp pressure.
Coffee Making Tips & Preparation • • Tamp down firmly (using approx. 15-20kgs of pressure). It’s important to apply consistent pressure every time. As a guide to dose, the top edge of the metal cap on the tamper should be level with the top of the filter basket AFTER the coffee has been tamped. This will minimise under or over dosing the coffee. the Razor™ Precision dose trimming tool Insert the Razor™ into the coffee basket until its shoulders rest on the rim of the filter basket.
PAge header..... Coffee Making Tips & Preparation PURGING THE GROUP HEAD • Before placing the portafilter into the group head, run a short flow of water through the group head, turning the Control Dial to the ‘Espresso’ position. This will purge any ground coffee residue from the group head and stabilise the temperature prior to extraction. TEXTURING MILK INSERTING THE PORTAFILTER Place the portafilter underneath the group head so that the handle is aligned with the INSERT position.
COFFEE MAKING TIPS & PREPARATION • • With the milk spinning, slowly lower the jug. This will bring the steam tip to the surface of the milk and start to introduce air into the milk. You may have to gently break the surface of the milk with the tip to get the milk spinning fast enough. Keep the tip at or slightly below the surface, continuing to maintain the vortex. Texture the milk until sufficient volume is obtained. • Lower the tip beneath the surface, but keep the vortex of milk spinning.
CARE & CLEANING 22 BES810BSS_ANZ_IB_E14.
CARE & CLEANING INSTALLING/REPLACING THE FILTER IN THE WATER TANK 1 2 3 4 5 6 REPLACEMENT DUE Soak the water filter for 5 minutes Rinse filter & mesh Assemble Set date 2 months ahead The water filter provided helps to prevent scale build up which over time can affect the performance of your machine, potentially causing blockages and heating problems. Replacing the water filter every two months will reduce the mineral build up in the machine.
CARE & CLEANING DECALCIFYING DECALCIFYING THE MACHINE After regular use, hard water can cause mineral build up in and on many of the internal components, reducing water flow, power of the machine, and affecting the quality of coffee. We advise decalcifying the machine on a regular basis (every 2-3 months) using a mixture of white vinegar and water. Use the following as a guide: • Solution for decalcifying • • • Diluted Solution (for softer water).
PAge header.....
PAge header..... TROUBLESHOOTING 26 BES810BSS_ANZ_IB_E14.
PAge header..... TROUBLESHOOTING Problem POSSIBLE CAUSES WHAT TO DO Coffee does not run through • Machine is not turned On Ensure the machine is plugged in, switched On at the power outlet and the POWER button is pressed. • Water tank is empty Refer to ‘Filling The Water Tank’, page 14. • The Control Dial not in ‘Espresso’ position Turn the Control Dial to the ‘Espresso’ position • Coffee grind is too fine Ensure you use a suitable espresso grind. Refer to ‘The Grind’, page 18.
PAge header..... TROUBLESHOOTING Problem POSSIBLE CAUSES WHAT TO DO No crema • Coffee is not tamped firmly enough Refer to ‘Coffee Dose and, Tamping’, page 18. • Coffee grind is too coarse Ensure you use a suitable espresso grind. Refer to ‘The Grind’, page 18. • Ground coffee is not fresh Change to freshly roasted beans. Refer to ‘Bean Freshness’, page 21. • Filter holes are blocked Use the fine pin on the cleaning tool to clear the holes. Refer to ‘Cleaning The Steam Wand’ on page 25.
PAge header..... TROUBLESHOOTING Problem POSSIBLE CAUSES WHAT TO DO Coffee drips from the portafilter spouts • The water tank is empty or low Refer to ‘Filling The Water Tank’, page 12 • Coffee grind is too fine Ensure you use a suitable espresso grind. Refer to ‘The Grind’, page 18. • Too much coffee in basket Refer to ‘Coffee Dose and Tamping’, page 18. • Machine is blocked by mineral deposits Decalcify the machine. Refer to ‘Decalcifying’, page 24.
PAge header..... TROUBLESHOOTING Problem No hot water Milk is not smooth after texturing Machine is not working POSSIBLE CAUSES WHAT TO DO • Steam Wand is blocked Use the pin on the cleaning tool to clear the opening. If the steam wand continues to be blocked remove the tip of the steam wand using the spanner in the middle of the cleaning tool. Refer to ‘Cleaning the Steam Wand’, page 25. • Empty tank Fill tank. • Steam Wand is blocked Use the pin on the cleaning tool to clear the opening.
COFFEES TO TRY BES810BSS_ANZ_IB_E14.
COFFEES TO TRY CAPPUCCINO A single shot of espresso with textured milk, garnished with drinking chocolate. ESPRESSO Intense and aromatic, it is also known as an espresso or short black and is served in a small cup or glass. lATTé A latté consists of a single espresso with textured milk and approx. 10mm of foam. MACChIATO Traditionally served short, the macchiato is also poured as a long black with a dash of milk or a dollop of textured milk.
NOTES 33 BES810BSS_ANZ_IB_E14.
BES810BSS_ANZ_IB_E14.
BES810BSS_ANZ_IB_E14.
Breville Customer Service Centre Australian Customers New Zealand Customers Mail: Mail: PO Box 22 Botany NSW 2019 AUSTRALIA Private Bag 94411 Botany Manukau 2163 Auckland NEW ZEALAND Phone: 1300 139 798 Phone: 0800 273 845 Fax: Fax: (02) 9384 9601 Email: Customer Service: askus@breville.com.au 0800 288 513 Email: Customer Service: askus@breville.co.nz www.breville.com.au www.breville.com.nz Breville is a registered trademark of Breville Pty. Ltd. A.B.N. 98 000 092 928. Copyright Breville Pty.
