Instruction Manual

33
g) Place descale solution into water tank,
fill with cold water to MAX line, (if an
alternative cleaning solution is used,
please follow the manufacturer's
instructions accordingly). Lock water
tank back into position at the back
of the machine.
NOTE
If water tank has not been removed, replaced or
is empty, “FILL TANK” will appear on the LCD.
NOTE
Emptying boilers typically takes 5-10 minutes.
If the machine was turned off at this stage,
follow '1 - Prepare for Descale' again.
3 – Begin Descale
a) Press 1 Cup button and the LCD screen
will show countdown time (20 minutes).
During this time, the machine will fill
boilers with descale solution and heat to
temperature. There may be some water
flow through the group head during this
time. Allow the countdown timer to reach
0 as this allows solution sufficient time to
dissolve scale build up. However you can
proceed to the next step at any time by
pressing the 1 Cup button.
b) Place a cloth over the drip tray to stop
steam escaping.
c) Empty boilers by repeating steps 2c
and 2d.
d) Empty drip tray and insert back to place.
e) Empty water tank then rinse and fill
with clean water to the MAX line. Lock
water tank back into position.
4 – Flush Boilers
a) Press 1 Cup button and the LCD screen
will show countdown time (20 minutes).
During this time, the machine will fill boilers
with fresh clean water and heat to temperature.
You can proceed to the next step at any time by
pressing the 1 Cup button.
b) Place a cloth over the drip tray to stop
steam escaping.
c) Empty boilers by repeating steps 2c and 2d.
d) Empty drip tray and insert back into place.
e) Empty water tank then rinse and fill with
clean water to the MAX line. Lock water
tank back into position.
5 – Repeat Step 4 Flush Boilers
We recommend flushing boilers again to
ensure any residual descale solution is
released from the boilers.
Press POWER button to escape the Descale
mode. The descale process is now complete
and ready to use.