Instruction Manual

10
FILTER RESET
• The filter reset light will illuminate red
indicating that the filter needs to be replaced.
• Replace the filter according to the directions
found under Replacing the Filter in this book.
• Once the filter is replaced, press and hold the
POWER button for 5 seconds to reset the
Filter Reset light.
• The built-in timer for the filter reset is 4,320
operating hours.
NOTE
For best performance, the filter should be
cleaned at least monthly as per the instructions
found in the Care, Cleaning & Storage section
of this book.
Care, Cleaning
& Storage
The air purifier and filter should be cleaned at
least once every month. Ensure the air purifier
is switched off and disconnected from the power
outlet and allow all parts to cool before cleaning
or storing.
• Use a clean, dry cloth to clean all external
surfaces of the air purifier.
NOTE
More frequent cleaning may be required
depending on environmental conditions.
BREVILLE RECOMMENDS
• Always ensure the air purifier is turned off,
switched off at the power outlet and unplugged
and allow the unit to cool before performing
any cleaning or filter replacement.

DO NOT stick any foreign objects or your
fingers inside the air inlet/outlet of this unit.

DO NOT use gasoline, benzine, thinner,
harsh cleaners, etc. on and/or in the unit
while cleaning as they will damage the unit.

NEVER use alcohol or other solvents
on this unit.
FILTER CLEANING AND REPLACING
WARNING
The filter is not washable. Do not immerse any
part of the air purifier in water as it will cause
damage.
• The Pre-filter should be cleaned at least once
every month using a vacuum cleaner. Gently
vacuum using a hand-tool attachment such as
a brush or upholstery tool. Clean more often if
required.
• Do not use any solutions, hard bristle
brushes or sharp objects to clean as this
can cause damage.
• Replace the filter as indicated using the
instructions following.