Instruction Manual

9
Functions
OPERATING YOUR AIR PURIFIER
1. Press the POWER button to turn on
and the
POWER symbol light will
illuminate.
2. The air purifier will begin operation.
3. The air purifier will begin operation in the
last setting selected, including Night mode
and timer.
4. To adjust how the air purifier operates, follow
the directions below.
NOTE
The filter reset light will illuminate red
indicating that the filter needs to be replaced.
To reset the indicator after the filter has been
replaced, press and hold the
POWER
button for 5 seconds and the filter reset light will
turn off.
Microbe Shield
TM
/NIGHT MODE
The Microbe Shield
TM
and Night Modes utilise
the same button on the control panel. Pressing
the
Microbe Shield
TM
/NIGHT button will
cycle through these two settings.
Microbe Shield
TM
• Press the Microbe Shield
TM
/NIGHT mode
button until the Microbe Shield
TM
indicator
light illuminates to turn it on.
• Press the button repeatedly until the light
extinguishes to turn off this function.
Night Mode
• To turn on Night Mode, press the
Microbe
Shield
TM
/NIGHT button until the Night
indicator light starts to blink.
• After 10 blinks, all indicator lights on
the control panel will turn off as the unit
enters night mode and the fan speed will
automatically change to Low.
• Press any button on the control panel to
re-engage the control panel and turn off
night mode. The Night indicator light will
extinguish.
FAN SPEED/TURBO MODE
NOTE
The air purifier will resume in the last
programmed setting once it has been turned
off, even if turned off at the power outlet. If the
last programmed setting was Night mode, once
turned on, the control panel will illuminate
with the Night indicator light blinking as a
reminder that Night mode has been set.
• Press the
FAN SPEED button repeatedly
until the desired speed is illuminated on the
control panel.
• There are 4 fan speeds: Low, Medium, High
and Turbo.
• The purifier has reached Turbo mode when
all three lights are illuminated on the control
panel at the same time.
NOTE
When changing the fan speed, the unit may
take a few seconds to adjust.
TIMER
• The air purifier can be set to operate for
timed intervals of 2 hours, 4 hours and 8
hours, stopping automatically when the
selected operating time has elapsed.
• If no timer is set, the air purifier will
continuously operate until the unit is
manually switched off.
• Press the
TIMER button repeatedly until
the desired interval hours are illuminated on
the control panel.
• For continuous operation, press the
TIMER button repeatedly until there are no
lights illuminated under the timer intervals.