the AirDynamic 3D™ Connect Instruction Book - Suits all LPF308 Models
c Contents 2 Breville Recommends Safety First 6 Components 7 Control Panel 8 Features 9 Assembly 11 Operation 12 Functions 15 Wi-Fi Connectivity 18 Care, Cleaning & Storage 19 Troubleshooting BREVILLE RECOMMENDS SAFETY FIRST At Breville we are very safety conscious. We design and manufacture consumer products with the safety of you, our valued customer, foremost in mind. In addition, we ask that you exercise a degree of care and adhere to the following precautions.
• Disconnect the power plug before dismantling, assembling or before cleaning and when the air circulator is not in use. • Avoid touching moving parts of the air circulator. • Never insert fingers, pencils or any other objects through the guards whenever the power plug is connected, in particular while the air circulator is switched on. • The air circulator must not be used if the guards are not fastened correctly, according to instructions provided in this book.
IMPORTANT SAFEGUARDS FOR ALL ELECTRICAL APPLIANCES • Fully unwind the power cord before use. • Connect only to a 230V or 240V power outlet. • The appliance must be used on a properly grounded outlet. If it is not sure, please consult a qualified electrician. • Do not, under any circumstances, modify the power plug or use a power plug adapter. • Do not place this appliance on or near a heat source, such as hot plate, oven or heaters.
• To protect against electric shock, do not immerse the power cord, power plug or appliance in water or any other liquid or allow moisture to come in contact with the part, unless it is recommended in the cleaning instructions. • Any maintenance other than cleaning should be performed at an authorised Breville Service Centre. • It is recommended to regularly inspect the appliance. To avoid a hazard, do not use the appliance if power cord, power plug or appliance becomes damaged in any way.
c Components FRONT VIEW REAR VIEW G A H I J K B L M C D N E O P F A. B. C. D. E. F. G. H. 6 Front grille Pedestal tube Control panel with LED display Anti-topple base Allen Key with Hex and Phillips bit Remote control Rear grille Fan blades Q I. Rear grille locking nut J. Motor shaft K. Blade cap L. Motor shaft pin M. Circulator motor head N. Power inlet O. Hexagon screw P. Power adaptor Q.
c Control Panel OSC OSC ECO F A G B C H TIMER NATURAL TURBO I D J E A. B. C. D. E. VERTICAL OSCILLATION HORIZONTAL OSCILLATION TIMER NATURAL MODE POWER ON/OFF F. G. H. I. J.
F Features WHAT IS AN AIR CIRCULATOR? Traditional fans will move air that is directly in contact with them, pulling air from behind to the front, with the benefit of cooling being felt only when directly facing you. Usually traditional fans are only used during the warmer months. Air circulators on the other hand, work to keep all air in a room in motion, moving around constantly and creating an air circulation pattern that will make the whole room more comfortable.
a Assembly BEFORE FIRST USE Fig 2 Before using your Breville pedestal air circulator for the first time, remove all packaging material and promotional labels. Check for any missing or damaged parts as per the components list. w IMPORTANT: When unpacking the air circulator, check to see you have received all the items listed in the components list, before discarding the packaging. ASSEMBLING THE PEDESTAL STAND AND BASE 1.
3. To place the rear grille onto the motor head, align the motor head with the locating tab on the rear grille. Ensure the upward arrow mark on the motor head aligns with the upward arrow mark on the rear grille. 4. Refit the rear grille locking nut and secure the rear grille by turning the locking nut clockwise (Fig 5). Make sure the rear grille has not slipped off the locating pins before tightening. This should be done by hand. Do not use force to secure. Fig 6 7.
o Operation OPERATING YOUR BREVILLE AIR CIRCULATOR w 1. Place the air circulator on a flat surface. Use the Where to Position Your Air Circulator section in this book for positioning depending on requirements. 2. Insert the power plug into a 230V or 240V power outlet and switch the power outlet on. The LED display will illuminate to display the current room temperature. The air circulator is now in standby mode. button to turn the air 3. Touch the circulator on.
o Functions MODE This Breville AirDynamic 3D™ Connect air circulator has 4 modes: NORMAL, TURBO, NATURAL and SMART ECO. The air circulator will start automatically on NORMAL mode on speed 1 once it is switched on. NORMAL MODE NORMAL mode has 8 fan speed settings; setting 1 for lowest fan speed up to setting 8 for the highest fan speed. To choose a fan speed, touch the or buttons until the desired speed number is reached and the speed will adjust automatically.
The air circulator will automatically adjust the fan speed based on the following programmed rules. Ambient T (°C) Air circulator speed < 26 Speed 1 26 – 28 Cycle between speed 2, speed 3 and speed 4. Operation for 5 secs on each speed. 29 – 34 Cycle between speed 5, speed 6 and speed 7. Operating for 5 secs on each speed. > 35 n Speed 8 NOTE: Fan speed in this mode cannot be manually adjusted.
REMOTE CONTROL The Breville air circulator comes with a remote control. This remote control features the same buttons as the control panel (except the Wi-Fi function) on the air circulator and can be used the same way. The remote control includes 1 x CR2032 3V Lithium battery. This Lithium battery is protected by an isolating slip. Before first using the remote control, remove the battery isolating slip by pulling the slip outwards away from the remote control.
i-Fi W Connectivity The AirDynamic 3D™ Connect air circulator can offer remote operation by using a home Wi-Fi connection and the Breville Home Connect™ app downloaded to a compatible mobile phone through the Google Play store or Apple App store. To go straight to the appropriate app store, Scan the QR code below. SET UP YOUR AIR CIRCULATOR 1. Ensure the mobile device is connected to a home Wi-Fi network. 2. The air circulator must be on standby mode.
Voice Assistants The Breville AirDynamic 3D™ Connect comes with the added feature of voice assistance, allowing you to control your air circulator using your voice by linking your Breville Home Connect™ app with Amazon Alexa and Google Home/Assistant. To link your Breville Home Connect™ app account with either Amazon Alexa or Google Home/ Assistant,, refer to the instructions on www.Breville.
NOTE Currently, Amazon Alexa does not support the following settings: • Timer VOICE CONTROL WITH GOOGLE HOME/ASSISTANT Before you can voice control your Breville AirDynamic 3D™ Connect with Google Home/Assistant, you need to link the Breville Home Connect™ account to the Google Home/Assistant app as per instructions.
TIPS for Amazon Alexa and Google Home/Assistants • Configure your Amazon Alexa or Google Home/Assistant compatible devices with the "Amazon Alexa" or “Google Home/Assistant” app if using, or simply download onto your phone. • You will find your device listed as the Breville product name in your Breville Home Connect™ app account. Tap on the device in the app to rename your device for more convenient voice commands, e.g. “Circulator Living Room”or give it a name, e.g. "Kenny".
C are, Cleaning C & Storage CARE AND CLEANING Always switch the Breville air circulator off. Switch off at the power outlet and unplug from the power outlet prior to cleaning the motor head, pedestal tube, anti-topple base, grilles and fan blades. To clean the outside of the air circulator, wipe the exterior with a soft, damp cloth. Never use an abrasive cleaner. To clean the fan blades and remove dust that may have accumulated, use a soft, damp cloth or a vacuum cleaner with the brush attachment.
Breville Customer Service Centre Australian Customers New Zealand Customers Phone: 1300 139 798 Phone: 0800 273 845 Web: Web: www.breville.com www.breville.com Breville, the Breville logo, AirDynamic 3D and Breville Home Connect are trademarks of Breville Pty. Ltd. Android is a trademark of Google LLC. All other brands may be trademarks of their respective owners. Breville’s products are distributed in New Zealand under license. A.B.N. 98 000 092 928.
