Instruction Manual

10
3. To place the rear grille onto the motor head,
align the motor head with the locating tab
on the rear grille. Ensure the upward arrow
mark on the motor head aligns with the
upward arrow mark on the rear grille.
4. Refit the rear grille locking nut and secure
the rear grille by turning the locking nut
clockwise (Fig 5). Make sure the rear grille
has not slipped off the locating pins before
tightening. This should be done by hand.
Do not use force to secure.
Fig 5
5. Align the grooves found at the back centre
of the blade with the motor shaft pin and
push all the way down.
n
NOTE
The back of the blade can be distinguished
from the front by a distinctive O symbol found
on the blade fin.
6. Refit and secure the blade cap onto the
motor shaft by turning counter-clockwise
(Fig 6). This should be done by hand. Do
not use force.
Fig 6
7. Place the front grille onto the rear grille
so that the left line mark on the top of the
rear grille is aligned with the line mark
on the front grille. Turn clockwise to lock
into place.
HINT:
Once the front and rear grilles are assembled
correctly, the Breville logo will be straight.
8. Securely tighten the assembled grilles
using the Phillips screw and the Allen key
provided (Fig 7).
TIGHTEN
Fig 7
9. Connect the power adaptor into the power
inlet found on the anti-topple base. The air
circulator is now ready for use.