Owner's manual

ManualsBrandsBrewer ManualsFurnitureAssistPRO

Document # 101522 0608 REV A ER 784 14

TABLE ADJUSTMENTS (CONTINUED)

on the foot control will indicate if the “Auto-Run” mode

is on or off. To set the program mode using the hand

pendant, simultaneously depress the program recall

number “3” and number “4” buttons for ve seconds

until two beeps are heard.

5. When the table is moving in the auto run mode, motion

of the table can be stopped by:

a. Tapping the “Stop” button on the foot control.

b. Tapping any pedal or button on the foot control.

c. Depressing any button on the hand pendant

Note: For emergency situations, the table can be turned

off using either of the two lighted switches located

at the top of the backrest. See gure 9.

Programming the Table with the

Foot Control

1. Using the foot control pedals, move the table to the

desired position. (see gure 10) Tap the black “Pro-

gram Set” button. The four blue “Program Recall”

buttons will ash. Tap one of the blue buttons to store

the position. The blue light will stay lit for that position

and two beeps will sound.

Note: The blue lights will ash for three seconds, after

which the program set mode is discontinued.

2. Move the table to a new position and repeat step 1 to

store up to three additional positions.

3. Any of the four stored positions can be re-pro

grammed by following the steps above.

Note: if the treatment pan tray is out, the position

recall will not work if the pre-set position requires the

legrest to move upward.

Safety

The table has a built in safety feature which helps avoid injury to the patient or physician when recalling a pro-

grammed position in the “Auto-Run” mode:

1. The table will stop moving downward once the legrest (in the stowed position) reaches a height of four inches

off the ground

2. The legrest will stop one inch from the lift column shrouding.

3. The pelvic tilt will stop after moving to 10 degrees

Programming the Table with the

Hand Pendant

1. Move the table to the desired position. Simultaneous-

ly depress the number “1” and the number “2” “Pro-

gram Recall” buttons. (see gure 11) Release the two

buttons. Depress one of the four “Program Recall”

buttons to store the position. Two beeps will sound.

Note: The Program Set Mode will remain active for

three seconds after simultaneously depressing the

number “1” and the number “2” “Program Recall” but-

tons.