Manualshelf

Owner`s manual

ManualsBrandsBriarwood ManualsGas HeaterBRII/90
891011121314151617
OM-BRII/90I.PUB Page 15 Rev. Date: Nov 27, 2003
Printed: February 8, 2005
Assembly—General / Optional
OPTIONAL INSTALLATION INSTRUCTIONS
Optional Gold Trim Installation:
Assemble the trim strips as shown in (fig 12) and attach to the shroud outer edge using the screws provided. Return
to step 4 and continue the installation.
Optional Fans Installation: (Note: The following instructions pertain to both fans on the left and right sides of the stove.)
1. Determine which side of the stove the power cord for the fan should be located.
2. Install a grommet in the 5/8” hole on each side of the shroud. Install a grommet in the bottom 5/8” hole of the fan
housing piece (Fig. 1 on page 16) which will contain the rheostat.
3. Slide the wires, which are attached to the shield box, through the grommets on the shroud. Note: It may be easier
to slide the wire with the larger male connector through first.
4. Install Bomax fan (with printing on fan right side up) and finger screen (Fig. 21). The fan attaches from the front, to
the fan housing, with the finger screen attaching under the outside 2 fan mounting screws. The screen will need to
be bent to act as a finger protector (Fig. 21).
5. Mount the rheostat, with 2 screws, as shown in Fig. 21. Connect the green ground wire by using the green screw
& star washer provided, be sure to place the star washer between the round lug & the frame of the housing. Insert
a wire, from the rheostat, with a male connector and a wire with a female connector through the grommet in the
fan housing, connect these 2 wires to the male and female connectors on the shield box wiring harness. Connect
the remaining male & female connectors to the fan. Connect shield box wiring harness, on other side of unit, to fan
on other side using same method.
6. Proceed to step 13 on page 14.
See the electrical diagram (Fig 11 on page 16)
for electrical connection.
Note: the fans are connected in parallel.
Fig 12
Optional Gold Trim
Left
L-Brackets X2
Top
Right
Brass Screws X2
Screw
Screw
17”
Fig 20 Fig 21