Installation Instructions

Installation Guide
Tools Required
Drill LevelPhillips ScrewdriverSay Glasses
1 - Level the Cabinet
To level the cabinet lay the level (not included) across the top of the cabinet. If adjustment is needed use shims (not included)
to level the cabinet from front to back and le to right.
2 - Attach Cabinet to Wall
Aer you have leveled your cabinet, (vanity or linen) attach the cabinet to the wall with 2 screws (not included) into the wall
studs through the back top rail. See Fig#1
3 - Install Hardware
Hardware for the doors and drawers is attached to the inside of the cabinet in a plastic bag. Measure and mark with a nail set
(not included) or other sharp object the desired location of the cabinet hardware using a 3/16” brad point drill bit, slowly drill
a hole from the front side of the door/drawer front. Attach the hardware to the front of the doors and drawers with the screws
provided.
4 - Adjust the Door
Door alignment may have shied during shipping. To realign door, follow the instructions below:
5 - Adjust the Drawer Front
Extend drawer and squeeze tabs on front locking device to release, and the drawer will remove easily. (See Fig #2)
e plastic levers that slide forward and back adjust the levelness of the drawer front. Slide the lever forward
(toward the drawer front) to lower that side, slide the lever back to raise that side. (Fig. 3). If still not level, locate the screw
attaching the drawer glide to the cabinet frame on the side
of the drawer that needs to be raised to achieve level. Using a
phillips head screwdriver, loosen the screw, raise the drawer
glide to the desired height, and retighten the screw. (Fig. 4).
To install the drawer, line the glides up on the drawer and the
cabinet. Push the drawer into the cabinet and pull the drawer
out to lock in place.
6 - Mirror Installation
Determine where you want to hang the mirror. Use wall anchors (not included) or screws (not included) that will be able to
handle the weight of the mirror.
Fig. #3 Fig. #4Fig. #2
Side Adjustment
Turn front screw counter-clock wise to move door
to the le, clockwise to move door to the right.
Range = 1/8” (3mm)
Height Adjustment
Loosen center screw on all hinges. Adjust door to
position and tighten screws.
Range = 1/4” (6mm)
Depth Adjustment
Turn back screw counter-clockwise to increase
door gap, clockwise to decrease gap.
Range = -1/32” (1mm) +3/32” (2mm)
Fig#1
Back Top Rail