User Manual

Getting Started
You should have received an email containing your default login information;
this will be used to configure your device and view tracking information (which
will be covered later in this user’s guide).
The first step in using your Spark Nano 7 is to charge it. To charge, plug the AC
adapter into a wall outlet. Then, gently insert the mini-USB charging end into the
charging port of your device. Ensure the mini-USB ends are properly aligned.
Charge the Spark Nano for at least 5 hours before first use. When fully charged,
the red light will be solid (and then will stop glowing after a prolonged period of
remaining plugged in after it’s fully charged). When the device is done charging,
disconnect it from the charger and press the power button to turn the device
on. Make sure all the rubber port covers are securely in place before use.
It is important that the tracker have a clear view of the sky. Since the device is
motion-activated, it is not sufficient to leave it outside or on a windowsill for it to
register. It must be moving in order to register and report its location.
To power on the unit, hold down the power button for around 3 seconds, also