A1.210619 BridgeIP LLC. 113 South Bridge Street Smithville, MO 64089 Call us at: (816) 532-8451 Visit bridgecomsystems.com for all of your radio support and education needs.
www.bridgecomsystems.com contactus@bridgecomsystems.
WELCOME Thank you for purchasing the Bridge Pro 268U two- way radio. The goal of the BP- 268U is to provide a cost- effective, feature rich, easy- to- use radio. This Owner’s Manual will acquaint you with the features and operation of the BP- 268U. Every effort has been made in the preparation of this manual in order properly operate the radio before use.
TABLE OF CONTENTS Safety Information and Safety Warning Accessories Getting Acquainted Basic Operation Programmable Key Function Technical Specifications Warranty and Service FCC Warning and Compliance Statement Page 2, 3 Page 4 Page 5 Page 6 Page 7-10 Page 11 Page 12 Page 13-16 1
SAFETY INFORMATION This radio is for occupational use only, and is to be used under work related conditions. As a user of this radio be fully aware of hazards to RF exposure. The Federal Communications Commission (FCC), with its action in General Docket 93-62, November 7, 1997, has adopted a safety standard for human exposure to Radio Frequency (RF) electromagnetic energy emitted by FCC regulated equipment.
SAFETY WARNING Do not transmit the radio without the antenna attached, damaged antenna or touch the antenna while transmitting. Strong electromagnetic waves are emitted from the radio which may damage the radio or cause an RF burn to your skin. Do not use non-approved accessories with your radio. Unauthorized accessories may create unauthorized RF emissions or cause damage to the radio or may result in illegal operation.
ACCESSORIES 1. Standard Accessories Li-ion Battery Pack Antenna Belt Clip Wrist strap Charger AC Adaptor Instruction Manual 2.
GETTING ACQUAINTED Channel Selector Antenna VOLUME Switch Led Indicator PF3 KEY PTT KEY Speaker Mic-SP jack PF1 KEY MIC MIC PF2 KEY Indicator Status: 1. Red light flashes: Battery needs charged 2. Red light solid on: Transmit 3. Green light flashe: Scan mode 4. Green light on: Receive matched carrier 5. Blue LED on: Receive matching digital signal 6.
BASIC OPERATION Ensure the antenna and a fully charged battery have been properly attached before attempting the following steps. 1. Power on the radio Turn the volume knob clockwise to turn on the radio, after approximately 5 seconds the Green LED will turn on, once illuminated after approximately 5 seconds you will hear a power on beep/announcement. 2. Adjust Volume Turn the volume knob to adjust the volume, clockwise will increase the volume and counter clockwise decreases volume. 3.
PROGRAMMABLE KEY FUNCTION The PF1, PF2, PF3 keys are programmable by PC software, each key can be enabled up to 3 functions. a short press, a 1 second press or a long press. Consult your radio provider for available functions that have been programmed into your radio. 1. Voltage In standby, press the key programmed as " Voltage" to check current battery capacity. 2. Power Switch In standby, press the key programmed as " Power Switch" to change the power level. 3.
7. VOX Level In standby, press the key programmed as" VOX Level", the radio will announce current VOX level. Press this key again to adjust VOX level or turn off VOX. 8. Scan In standby, press the key programmed as "Scan", the radio will start scanning the list on the current channel location, press this key again to turn off the scan function. 9.
14. Work Alone In standby, press the key programmed as "Work Alone " to turn on this function, the radio will announce "work alone on", press this key again to turn off work alone function. Note: After turning on the work alone function, the radio will send out an alarm after a preset time. 15.
20. Mic Quality In standby, press the key programmed as "Mic Quality", the radio will announce choose mic status. Note: Choose the mic quality according to your voice character to enable so the receiver can hear clearly. This function valid only for DMR channels. 21. Scene Mode During receiving, press the key programmed as "Scene Mode", to choose a suitable mode to allow the user to hear a clear voice. Note: This function valid only for DMR channels. 22.
TECHNICAL SPECIFICATIONS General Frequency Range Operation Type Channel Capacity Channel Spacing Phase-locked Step Operating Voltage Frequency Stability Operating Temperature Size Weight Antenna Impedance FCC ID FCC Approvals UHF: 450-512MHz DMR Digital and analog UHF 256 channels 12.5KHz (Narrow Band) 5KHz, 6.25KHz 7.4V DC ±20% /(2600mAh) ±1.
WARRANTY AND SERVICE Limited Warranty This product is warranted by BridgeCom Systems, Inc. to be free of defects in materials and workmanship for a period of one year from the date of purchase. If a defective part causes this product to operate improperly during the one-year warranty period, we will service it to the original owner free of charge if shipped to BridgeCom Systems at the owner’s expense. This warranty does not apply to any parts damaged due to improper use or violation of instructions.
FCC STATEMENTS WARNINGAND COMPLIANCE STATEMENT: This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference. (2) This device must accept any interference received, including interference that may cause undesired operation. This device complies with Part 15 of the FCC Rules. Operation is subject to the condition that this device does not cause harmful interference.
FCC STATEMENTS WARNINGAND COMPLIANCE STATEMENT: Electromagnetic Interference/Compatibility During transmissions, The radio generates RF energy that can possibly cause interference with other devices or systems. To avoid such interference, turn off the radio in areas where signs are posted to do so. DO NOT operate the transmitter in areas that are sensitive to electromagnetic radiation such as hospitals, aircraft,and blasting sites.
FCC PART 15.21 WARNING STATEMENT This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates and can radiate radio frequency energy. If not installed and used in accordance with the instructions, it may cause harmful interference to radio communications.
FCC PART 15.21 WARNING STATEMENT ■Licensing Information Use of the radio in USA is subject to the rules & regulations of FCC. Changes or modifications not expressly approved by our may void the user authority granted by the FCC to operate this radio and should not be made.
