User's Manual

TM
GE60 Installation Manual
580-00507, rev 1 29 of 46
3.6.1 Antenna and Radio installation
5. Install – Antenna
Slip antenna over pivot pin, ensuring that the elevation adjust pin is engaged with
slot in adaptor plate.
Figure 3-7.1
Note that when the radios come from the factory, they are mounted on the back of
the antenna in the vertical polarization position, that is, the diamond marking (see
insert below) on the front of the radio housing is to the right when viewed from the
front of the radio. For horizontal polarization, the radio needs to be removed from
the antenna and rotated so the diamond is at the top when viewed from the front.
Secure the antenna
with two (2) x 3/8-16
b
olts, lock washer, flat
washer and nylon
washers attach antenna
to the alignment plate.