User's Manual

TM
GE60 Installation Manual
580-00507, rev 1 30 of 46
Figure 3-8.1: Polarization diamond orientations: horizontal (right) and vertical (left)
Note: The blue color label indicates a high band radio and the red color label
indicates a low band radio
CAUTION!
It is critically important during installation to ensure the radios on each side
of the link are in the same polarization (horizontal-horizontal or vertical-
vertical). A link that has a radio on one side of the link set in the horizontal
polarization and the other side of the link set in the vertical polarization will
not operate properly.
Further, it is also critically important that a high-band radio is paired with a
low-band radio to ensure the system will operate properly. Prior to installation
check each radio to verify one is a high-band and the other is a low-band
version. The label on the radio will indicate the band (blue for high or red for
low).
6. Verify that the four (4) captive 3/8-16 bolts with lock and flat washer are in
place. A ½ inch open-end wrench is required to tighten them. It is important that all
four screws are tightened evenly (hand tight, 1 to 2 turns each and finally until the
lock washer is flattened)
Fi
g
ure 3-9.1 Ca
p
tive radio bolt detail