User's Manual
Table Of Contents
- Installation of E60 products
- General
- Equipment Packing & Unpacking
- Equipment Inventory for E60 products
- Qty Description
- Qty Description
- Installation Tools
- Radio Mount Installation E60 products
- Wall Mounting
- Pole Mounting
- 3.5.1 Antenna Mount Installation E60X products
- Radio Installation
- Cable Installation
- Antenna Alignment E60 systems
- Test Cable
- Operation of E60, E60X radios & configuration of network equipment
- Troubleshooting
TM
GE60 Installation Manual
580-00507, rev 1 32 of 46
Caution! It is very important that the azimuth bolts are tightened before any elevation
adjustment is done. The very narrow beamwidth of this antenna (0.6ยบ) makes it necessary
to completely tighten the bolts of the azimuth adjustment while adjusting the elevation
and vice versa.
8. Adjust elevation (up - down)
Figure 3-12.1 Elevation adjustment
1. Loosen (2)
antenna
mounting bolts
2. Rotate Elevation
adjust hex nut as
required to set
correct elevation.
3. Tighten all bolts
after the elevation
is set.