User's Manual
Table Of Contents
- Installation of E60 products
- General
- Equipment Packing & Unpacking
- Equipment Inventory for E60 products
- Qty Description
- Qty Description
- Installation Tools
- Radio Mount Installation E60 products
- Wall Mounting
- Pole Mounting
- 3.5.1 Antenna Mount Installation E60X products
- Radio Installation
- Cable Installation
- Antenna Alignment E60 systems
- Test Cable
- Operation of E60, E60X radios & configuration of network equipment
- Troubleshooting
TM
GE60 Installation Manual
580-00507, rev 1 42 of 46
Figure 3-10: Top view of test cable provided to check Link Quality & Receive Signal level
2. To read the Link Quality value of the radio, insert GND (ground) and QUAL
banana plugs into the voltmeter. Note the Link Quality voltage. After the radios
have performed an auto calibration the quality voltage should read 3.3v if the link is
aligned on the main antenna beam and there are no obstructions (i.e., trees,
buildings, etc…) in the path, the link distance is within the operating parameters of
the radio (see Section 2.4 above), and it is not raining heavily.