User's Manual
Table Of Contents
- Installation of E60 products
- General
- Equipment Packing & Unpacking
- Equipment Inventory for E60 products
- Qty Description
- Qty Description
- Installation Tools
- Radio Mount Installation E60 products
- Wall Mounting
- Pole Mounting
- 3.5.1 Antenna Mount Installation E60X products
- Radio Installation
- Cable Installation
- Antenna Alignment E60 systems
- Test Cable
- Operation of E60, E60X radios & configuration of network equipment
- Troubleshooting
TM
GE60 Installation Manual
580-00507, rev 1 19 of 46
3.4 Installation Tools
The following tools, not provided by BridgeWave, should be used for installing the radio:
Screwdriver, slotted 0.1 inch (2.5mm) wide
Open-end wrench 11/32 (9mm)
Open-end wrench 9/16 (14mm), 2 ea.
Open-end wrench ½ inch (13mm)
Ratchet with 6 inch (15cm) extension and 9/16 inch (14mm) deep socket
Wire stripper/cutter/crimp tool (10-16 gauge)
Electrical tape
Fish tape for pulling cable
Cable tie wraps
Hand-held DVM (digital voltmeter) with standard banana plug receptacles