Installation Guide

Installation/Installation/Instalación
Temporarily place slide bar on the
mounting brackets to check alignment.
If necessary, loosen the screws and
realign the mounting brackets.
Place the mounting brackets over the
wall anchors. Secure them to the
wall using the supplied screws.
Drive the wall anchors into the drilled
holes with a Phillips screwdriver.
Place sliding bar assembly on the
mounting bracket and then fix the
sliding bar with top cover.
Apply teflon tape to supply nipple.
Thread on supply nipple to 1/2" NPT
water supply. Apply teflon tape to
supply nipple and thread on bushing
with 12mm allen wrench.
9
Push on hand shower supply outlet
nipple and secure with set screw.
8
4 5 6
Drill 1/4" holes in marked locations.
Align brackets and mark drill holes in
desired location.
Determine the location of the sliding
bar.
1 2 3
7
Teflon Tape
12mm
Allen
Wrench
Connect Shower Hose. Installation complete.
1110
BRN-MCHS-CP
BRN-MCHS-BN
BRN-MCHS-CP
BRN-MCHS-BN