Installation Guide

ManualsBrandsBrienza ManualsKitchenTraditional Wall-Mount Pot Filler in Chrome

PACKING LIST

IMPORTANT NOTICES: Do not use petroleum-based products in this faucet.

Observe all local plumbing and building codes.

Common woodworking and plumbing tools and materials

After you open this package, please check to ensure that all of the following items are included.

Wall-Mount Pot Filler Faucet

EX:E002009 Rev:A

TROUBLE-SHOOTING

If you've followed the instruction carefully and your faucet still does not work properly, take these corrective steps.

Problem

Cause

Action

Leaks underneath handle. Cartridge has come loose.

Tighten the cartridge.

Aerator leaks or has an

inconsisitent water flow

pattern.

Aerator is dirty or worn

out or misfitted.

Unscrew the aerator to

clean or replace washer,

or replace the aerator.

Water will not shut off

completely.

Dirty or worn out washer

in cartridge.

Remove handle and cartridge

to check if the washer is damaged

permanently or dirty. Re-install

cartridge.

CAUTION: Maintenance

1. Replacement parts may be available at the store where you purchased your faucet.

2. Always turn off water and relieve pressure before working on your faucet.

NOTES: Cleaning Instructions

1. To keep the faucet clean, you should clean the faucet frequently and regularly.

2. Clean the faucet with clear water or mild liquid, rinse the faucet with clear water and then

dry the faucet with soft cotton cloths.

3. Do not use any abrasiv

e cleans

ers, cloths, or paper towel.

4. Do not use any acid or abrasive detergent.

Turn on the water supply

to the faucet and check

for leaks.

Remove the aerator and

open both handles to flush

debris from the faucet.

Turn off the water and

reinstall the aerator.

Faucet

Screw

Escutcheon

Mounting plate

Screw

Setscrew

Strap Wrench

1/8"1-5/16"

Sealant Tape

Y OU MAY NE E D

Allen Wrench

Summary of content (2 pages)

PAGE 1
7 18 Turn on the water supply to the faucet and check for leaks. Remove the aerator and open both handles to flush debris from the faucet. 19 Turn off the water and reinstall the aerator. Wall-Mount Pot Filler Faucet PACKING LIST After you open this package, please check to ensure that all of the following items are included. Setscrew CAUTION: Maintenance 1. Replacement parts may be available at the store where you purchased your faucet. Screw 2.
PAGE 2
INSTALLATION PROCEDURES 1 2 Install 2x4 backing flush with the studs, at the installation location. Install a 1/2” NPT supply pipe to extend no more than 1/2” (13mm) beyond the wall. 9 10 Drill four 1/8” holes at the marked locations. Apply thread sealant to the supply pipe. These surfaces to be flush. 1/2" Max mm) (13 3 4 Secure the supply pipe to the 2x4 backing. Complete the finished wall. Provide a 1-5/16” (33 mm) hole around the supply pipe.