Pressure Washer Operator's Manual

2. Insert carriage bolts through holes from outside of
unit and attach plastic knob from inside of unit
(Figure 2).Tighten by hand.
3. Place cleaning tank over holes on handle (viewing from
front of unit). Push the tree clips into the holes until
they sit flat against the cleaning tank (Figure 3).
3. Insert one “L” hook through hole just above cleaning
tank on left side of handle (viewing from front of unit).
Hold hook in place and attach plastic knob from inside
of unit (Figure 4).Tighten by hand.
4. Insert other “L” hook through hole just above cleaning
tank on right side of handle (viewing from front of
unit). Hold hook in place and attach plastic knob from
inside of unit (Figure 4).Tighten by hand.
Attach Detergent Siphon Hose to
Pump
Attach detergent siphon hose to barbed hose fitting on
pump (Figure 5).
Add Engine Oil and Fuel
• Place pressure washer on a level surface.
• Refer to engine operator’s manual and follow oil and fuel
recommendations and instructions.
NOTE: Check oil often during engine break–in. Refer to
engine operator’s manual for recommendations.
CAUTION
• Refer to engine operator’s manual for oil and fuel fill
information.
• Damage to equipment resulting from failure to follow this
instruction will void warranty.
Any attempt to crank or start the engine before it has
been properly filled with the recommended oil will result
in equipment failure.
SpeedClean™ 2200 PSI Pressure Washer
8
Hose Hook
Spray Gun
Hook
Figure 4 — Attach “L” Hooks to Handle
Figure 3 — Attach Cleaning Tank to Handle
Figure 2 — Secure Handle
Figure 5 — Attach Detergent Siphon Hose to Pump