Manual

UsageTips
° For most effective cleaning, keep spray tip from 8 to
24 inches (20 to 61 cm) awayfrom cleaning surface.
, if you get spray tip too close, especially using a high
pressure spray tip, you may damage surface being
cleaned.
, DONOTget closer than 6 inches (15 cm) when
cleaning tires.
Cleaning and Applying Detergent
,_kWARNING Chemical Burn Hazard.
Chemicals could cause burns resulting in death
or serious injury.
* DO NOTuse caustic liquid with pressure washer.
* Use ONLY pressurewasher safe detergents/soaps. Follow aiI
manufacturers instructions.
Toapply detergent, feiiew these steps:
1. Review use of spray tips.
2. Preparedetergent solution as required by job.
3. Placeend of detergent siphoning tube into detergent
container.
NOTICE Make sure the end of tube is fully submerged in
detergent while applying detergent.
NOTICE Contact with the hot muffler could damage
detergent siphoning tube.
, When inserting the siphon nto a detergent solution bottle, route
the tube so as to keep it from inadvertently contacting the hot
muffler_
4. Make sure black detergent spray tip is installed.
NOTICE Detergent cannot be applied with the high pressure
spray tips (White, Yellow or Red.
5. Make sure garden hose is connected to water inlet.
Checkthat high pressure hose is connectedto spray
gun and pump. Turn on water.
NOTICE You must attach all hoses before you start the
engine.
, Starting the engine without all the hoses connected and without
the water turned ONcould damagethe pump.
* Damageto equipment resulting from failure to follow this
instruction will void warranty.
6. Start enginefollowing instructions How to Start Your
Pressure Washer.
7. Apply detergentto a dr}' surface, starting at lower
portion of areato be washedand work upward, using
long, even,overlapping strokes.
8. Allow detergent to "soak in" for 3-5 minutes before
washing and rinsing. Reapplyas neededto prevent
surface from drying. DO NOTallow detergentto dr}' on
(prevents streaking).
NOTICE You must flush the detergent siphoning system
after each use by placing the tube into a bucket of clean
water, then run the pressure washer in low pressure for 1-2
minutes.
Pressure Washer Rinsing
For Rinsing:
1. Remove black detergent spray tip from nozzle
extension.
2. Select and install desired high pressure spray tip
following instructions How to UseSpray Tips.
3. Keepspray gun a safedistance from areayou plan to
spray.
A WARNING Kickbackfrom spray gun could causeyou
to fall resulting in death or serious injury.
° Operatepressurewasher from a stable surface.
° Beextremely careful if you must use the pressurewasher from
a ladder, scaffolding, or anyother similar location.
* Firmly grasp spray gun with both hands when using high
pressure spray to avoid injury when spray gun kicks bacL
4. Apply a high pressuresprayto asmall areaandthen
check surfacefor damage,if no damageisfound, you
can assumeit is okayto continue rinsing.
5. Start at top of areato be rinsed,working down with same
overlappingstrokes asyou usedfor cleaning.
15