Manual

.
8.
9.
10.
11.
Reinstall spray tip into nozzleextension.
Reconnect nozzleextensionto spray gun.
Make sure garden hose is connectedto water inlet.
Checkthat high pressure hose is connectedto spray
gun and pump. Turn on water.
Start enginefollowing instructions How to Start Your
Pressure Washer.
Test pressurewasher by operating with each quick
connect spray tip.
O-Ring Maintenance
Purchasean O-Ring/Maintenance Kit, model 196002GS,by
contacting the nearestauthorized service center, it is not
included with the pressurewasher. This kit includes
replacement o-rings, rubber washer and water inlet filter.
Referto the instruction sheet provided in the kit to service
'our unit's o-rings.
WARNING The high pressure stream of water that
this equipment produces could cut through skin
and its underlying tissues, resulting in serious
injury and possible amputation.
o NEVERrepairleakingconnectionswithsealantof anykind.
Replaceo-ringor seal.
Engine Maintenance
A WARNING Unintentional sparking could cause fire or
electric shock resulting in death or
serious injury.
WHENADJUSTINGOR MAKING REPAIRSTO YOURPRESSURE
WASRER
o Disconnect the spark plug wire from the spark plug and place
the wire where it cannot contact spark plug,
WRENTESTINGFORENGINESPARK
o Use approved spark plug tester,
o DONOTcheckfor spark with spark plug removed.
Oil
Oil Reeemmendatiens
We recommend the use of Briggs & Stratton Warranty
Certified oils for best performance. Other high-quality
detergent oils are acceptableif classified for service SF, SG,
SH, SJ or higher. DONOTuse specialadditives.
Outdoor temperatures determine the proper oil viscosity for
the engine. Usethe chart to select the best viscosity for the
outdoor temperature rangeexpected.
oF
104
86
68
50
32
14
-4
-22
* Bel0w40°F
o
o
°C
os_"_ 30402010
-°
._, -10
-20
=30
(4°C) the use of SAE30 will result in hard starting.
** Above 80°F (27°C) the useof 10W30 may cause increased oil
consumption. Checkoil level more frequently.
Checking 0il Level
Oil level should be checked prior to each use or at bast
ever},8 hours of operation. Keepoil level maintained.
1. Make sure pressure washer Mson a level surface.
2. Remove oil dipstick and wipe dipstick with clean cloth.
Replaceand tighten dipstick. Remove and and check oil
level.
3. Verify oil is at FULL mark (top hob) on dipstick.
Replaceand tighten dipstick.
Full
Adding Engine Oil
1. Make sure pressure washer is on a level surface.
2. Check oil level as described in Checking 0il Level
3. if needed,slowly pour oil into oil fill opening to the
FULL mark (top hob) on dipstick. DONOToverfill.
HOTICE Overfilling with oil may causethe engineto not
start, or hard starting.
o DONOToverfill.
o if overthe FULLmarkon dipstick,drainoil to reduceoil levelto
FULLmarkondipstick.
4. Replaceand tighten dipstick.
19