Manual

AcidEngine Oil
1. Place pressure washer on a fiat, level surface.
2. Cleanarea around oil fill and removeyellow oil fill
cap/dipstick.
3. Hold neck of supplied oil pouch and removecap.
4. Slowly pour contents of oil pouch into oil fill opening.
Checking oil level frequently, fill to FULLmark (top
hob) on dipstick.
Full
NOTICE Pauseto permit oil to settle. Wipe dipstick clean
each time oil level is checked. DO NOToverfill.
NOTICE improper treatment of pressure washer could
damage it and shorten its life.
, DO NOTattempt to crank or start the engine beforeit has been
properly servicedwith the recommended oil. This could result in
an enginefailure.
WARNING Fuelandits vaporsare extremelyflammable
andexplosivewhich could causeburns,
fire or explosionresulting in death or
seriousinjury.
WHENADDINGFUEL
° Turn pressurewasher engineOFFand let it cool at least 2
minutes before removingfuel cap. Loosen cap slowly to relieve
pressure in tank.
* Fill fuel tank outdoors.
° DONOT overfill tank. Allow spacefor fuel expansion.
, if fuel spills, wait until it evaporatesbefore starting engine.
, Keepfuel away from sparks, open flames, pilot lights, heat, and
other ignition sources.
, Checkfuel lines, tank, cap and fittings frequently for cracks or
leaks. Replaceif necessary.
, DONOTlight a cigaretteor smoke.
,
2.
Cleanarea around fuel fill cap, remove cap.
Slowly add regular unleadedfuel (A) to fuel tank (B). Be
careful not to overfill. Allow about 1.5" (4 cm) (C) of
tank space for fuel expansion.
5. Replaceoil fill cap/dipstick and fully tighten.
Add Fuel
Fuel must meet these requirements:
, Clean,fresh, unleadedgasoline.
, A minimum of 87 octane/87AKI (91 RONL For high
altitude use, see High Altitude.
, Gasolinewith up to 10% ethanol (gas@@ is acceptable.
NOTICE Use of unapproved fuels could damagegenerator
and voids warranty.
, DONOTuseunapprovedgasolinesuchasE15andE85.
, DONOTmixoilingasolineormodifyengineto runonalternatefuels.
To protect the fuel system from gum formation, mix in a fuel
stabilizer when adding fuel. SeeStorage.All fuel is not the
same. if you experiencestarting or performance problems
after using fuel, switch to a different fuel provider or change
brands. This engine is certified to operate on gasoline. The
emission control system for this engine is EM (Engine
Modifications).
3. Install fuel cap and let any spilled fuel evaporatebefore
starting engine.
High Altitude
At altitudes over 5,000 feet (1524 meters), a minimum
85 octane/ 85 AKI (89 RON)gasoline is acceptable.To
remain emissions compliant, high altitude adjustment is
required. Operationwithout this adjustment will cause
decreasedperformance, increasedfuel consumption, and
increasedemissions. Seean Authorized Briggs & Stratton
dealerfor high altitude adjustment information. Operation of
the engine at altitudes below 2,500 feet (762 meters) with
the high altitude kit is not recommended.
8 BRIGGSandSTRATTON.CONI