Full Product Manual

Not for
Reproduction
6 BRIGGSandSTRATTON.COM
Assembly
Read entire operator’s manual before you
attempt to assemble or operate your new
electric pressure washer.
Your electric pressure washer requires some assembly
but is quickly ready for use. If you have any problems with
the assembly of your electric pressure washer, please call
the electric pressure washer helpline at [phone]. If
calling for assistance, please have the model, revision, and
serial number from the identification label available.
Unpack Electric Pressure Washer
1. Remove everything from carton.
2. Raise handle (A) to upright position by pulling up latch
on each side of handle. Push latches (B) down to
secure handle in place.
NOTICE The unit is equipped with a foldable handle. The
handle can be folded down for storage. See Final Storage
Procedures.
3. Ensure you have all included items prior to assembly.
Items Included in the Carton
• Main unit
• Operator’s manual
• Spray gun
• High pressure hose
• Spray wand with Quick Connect (QC)
• 7-in-1 nozzle
• Red high pressure nozzle
Check all contents. If any parts are missing or damaged, call
the electric pressure washer helpline at [phone].
Become familiar with each component before assembling
the electric pressure washer. Identify contents with the
illustration shown in Features and Controls.
Lubricate O-Rings
Lubrication of o-rings is extremely important for installation
and operation. The use of a lubricant (petroleum or
synthetic grease) during assembly helps seat o-rings
properly and provides an improved seal. It also helps
protect the o-ring from damage by abrasion, pinching or
cutting and extends the life of the o-ring.
NOTICE ALWAYS apply a small amount of lubricant on
o-rings prior to assembling the garden hose to the pump
(C), high pressure hose (D), spray wand (E) and spray
gun (F).
Lubricate all connections shown below, following these
instructions:
1. Inspect and clean connecting surfaces prior to
lubrication and assembly.
2. Use lubricants sparingly during assembly; a light film
is all that is required.
3. Use a small brush or cotton swab to apply grease
directly to o-rings where they are not accessible (QC
fitting, M22 fitting).
E
D
F
C
A
B
B