Full Product Manual

ManualsBrandsBriggs & Stratton ManualsOutdoor Power Equipment2000 PSI 3.5 GPM Electric Pressure Washer with POWERflow Plus Technology

Not for

Reproduction

Connect Hose and Water Supply to Pump

NOTICE DO NOT run the pump without the water supply

connected and turned on.

• Damage to equipment resulting from failure to follow this

instruction will void warranty.

1. Uncoil high pressure hose (A) and attach black end of

hose to base of spray gun (B). Tighten by hand.

2. Attach blue end of high pressure hose (A) to high

pressure outlet (C) on pump. Tighten by hand.

3. Run water through your garden hose for 30 seconds

to clean out any debris.

NOTICE DO NOT siphon standing water for the water

supply. Use ONLY cold water (less than 100°F (38°C)).

4. Before connecting garden hose (D) to water inlet (E),

inspect inlet screen (F). Clean screen if it contains

debris or have it replaced if damaged. DO NOT run

pressure washer if inlet screen is damaged.

NOTICE Using a One Way Valve (vacuum breaker or

check valve) at pump inlet could cause pump or inlet

connector damage.

• There MUST be at least 10 ft. (3 m) of unrestricted

garden hose between the pressure washer inlet and any

device, such as a vacuum breaker or check valve.

• Damage to equipment resulting from failure to follow this

instruction will void warranty.

5. Connect the garden hose (D) (not to exceed 50 ft. (15

m) in length) to the water inlet (E). Tighten by hand.

Connect Spray Wand and 7-in-1 Nozzle

1. Turn ON water, point gun in a safe direction, press

trigger lock button (G), then squeeze trigger to purge

pump system and spray gun of air and impurities.

2. Attach spray wand to spray gun. Tighten by hand.

3. Pull back on collar of spray wand, insert 7-in-1 nozzle

and release collar. Tug on 7-in-1 nozzle to make sure

it is securely in place. See How to Use Nozzles.

Checklist Before Starting Pump Motor

Review the unit’s assembly to ensure you have performed

all of the following.

1. Be sure to read Operator Safety and Operation before

using the electric pressure washer.

2. Check for properly tightened hose connections.

3. Check to make sure there are no kinks, cuts, or

damage to hoses.

4. Provide a proper water supply at an adequate flow.

5. Plug electrical power cord into a dedicated electrical

circuit rated for 120 Volts AC at 15 Amps that is

properly installed in accordance with all local codes and

ordinances. Check that circuit is not used to supply any

other electrical needs.

D E