Use and Care Manual

Not for
Reproduction
6 BRIGGSandSTRATTON.COM
Assembly
Read entire Operator’s Manual before you
attempt to assemble or operate your new
electric pressure washer.
Your electric pressure washer requires some assembly
but is quickly ready for use. If you have any problems with
the assembly of your electric pressure washer, please call
the electric pressure washer helpline at [phone]. If
calling for assistance, please have the model, revision, and
serial number from the identification label available.
Tools Needed
• Philips screwdriver #2
Unpack Electric Pressure Washer
1. Remove everything from carton.
2. Ensure you have all included items prior to assembly.
Items Included in the Carton
• Main unit
• Handle with accessory tray
• Spray gun
• High pressure hose
• Spray wand
• Quick Connect (QC) spray tips (3)
• Quick Connect (QC) foamer spray tip with detergent
bottle
• Handle support tubes (2)
• Screws (2)
• Operator’s Manual
Check all contents. If any parts are missing or damaged,
DO NOT use, call the electric pressure washer helpline at
[phone].
Become familiar with each component before assembling
the electric pressure washer. Identify contents with the
illustration shown in Features and Controls.
Attach Handle and Support Tubes
1. Push and hold lock-pin buttons (A) on each side of
the handle. Slide handle (B) down into each handle
support tubes (C) until lock-pins buttons snap into the
holes.
2. Slide handle support tubes (C) into slots on both
sides of main unit. Align holes and insert screws (D).
Tighten with a #2 philips screwdriver.
Lubricate O-Rings
Lubrication of o-rings is extremely important for installation
and operation. The use of a lubricant (petroleum or
synthetic grease) during assembly helps seat o-rings
properly and provides an improved seal. It also helps
protect the o-ring from damage by abrasion, pinching or
cutting and extends the life of the o-ring.
NOTICE ALWAYS apply a small amount of lubricant on
o-rings prior to assembling the garden hose to the pump
(E), high pressure hose (F), spray gun (G), and spray
wand (H).
Lubricate all connections shown below, following
these instructions:
1. Inspect and clean connecting surfaces prior to
lubrication and assembly.
2. Use lubricants sparingly during assembly; a light film
is all that is required.
3. Use a small brush or cotton swab to apply grease
directly to o-rings where they are not accessible (QC
fitting, M22 fitting).
H
G
E
F
A
B
C
D
C
D