Installation Guide

30
Maintenance
Servicing the System
WARNING
Generatorand utilityvoltage could cause electrical
shock or burn resulting in death or serious injury.
• DO NOT allow unqualified persons to operate or
servicethis equipment.
WARNING
With the battery connected, the generator may crank
and start without warning resulting in death or serious injury.
• Before servicing, stop the generator and disconnect the
negative (-) cable at the battery.
Before performing any generator maintenance, always do the
following steps
1. Push the ON/OFF Switch on the back of the generator to
the “OFF” (0) position.
2. Remove utility power to the generator to de-energize the
battery charger.
3. Unlock and open the roof as described in theAccess
Panelssection of this manual.
4. Remove the battery panel.
5. Remove the 15 Amp fuse from the fuse holder located
behind the battery panel.
6. Disconnect the negative (-) cable at the battery.
7. Perform service steps as specified.
8. Connect the negative (-) cable at the battery.
9. Install the 15 Amp fuse into the fuse holder.
10. Install the battery panel.
11. Close and lock the roof.
12. Restore utility power to the generator.
13. Push the ON/OFF Switch on the back of the generator to
the “ON” (I) position.
14. Set the generator mode to AUTO.
Maintenance Schedule
Follow the hourly or calendar intervals of operation,
whichever occurs first.
Every 8 Hours of Operation or Daily
Clean Debris
Check the Engine Oil Level
Every 100 Hours of Operation or Annually
Change the Air Filter
Change the Engine Oil and Filter
Replace the Spark Plugs
Check the Valve Clearance
Check the Circuit Breaker Torques
Annually
Clean the Oil Cooler Fins

Regular maintenance will improve the performance and
extend the life of the generator. See any authorized dealer for
service.
Emissions Control
Maintenance, replacement, or repair of the emissions control
devices and systems can be done by any non-road engine
repair establishment or an individual. However, to obtain "no
change" emissions control service, the work must be done by
a factory authorized dealer. See the Emissions Warranty.

Generator Maintenance
The generator’s warranty does not cover items that have
been subjected to operator abuse or negligence. To receive
full value from the warranty, the operator must maintain the
generator as instructed in this manual.
Some adjustments will need to be made periodically to
correctly maintain your generator.
All service and adjustments must be made at least once
each season. Obey the requirements in theMaintenance
Schedulechart.
Generator maintenance consists of keeping the unit clean.
Operate the unit in an environment where it will not be
exposed to excessive dust, dirt, moisture or any corrosive
vapors. The cooling air louvers on the enclosure must not
become clogged with snow, leaves, or other foreign material.
To prevent generator damage caused by overheating,
keep the enclosure cooling inlets and outlets clean and
unobstructed at all times.
Check the cleanliness of the unit frequently and clean when
dust, dirt, oil, moisture or other foreign substances are visible
on its exterior/interior surface. Inspect the air inlet and outlet
openings inside and outside the enclosure to make sure the
air flow is not blocked.
NOTICE Incorrect treatment of generator can damage it
and shorten its life.
• DO NOT expose generator to excessive moisture, dust,
dirt, or corrosive vapors.
• DO NOT insert any objects through cooling slots.
Cleaning the Generator

Not for
Reproduction