Operating instructions

4
Step 6
Model K 2200 IB: Slide the throttle
control to the fast position. Then move the choke
lever to the “CHOKE” position (only if engine is
cool). After starting, move the choke to “RUN”.
Step 7
Pull the starter handle. If
the engine fails to start after 3 pulls
squeeze the trigger gun to release
pressure, and repeat step 7.
OPERATING INSTRUCTIONS
Step 1 Connect the high pressure hose to the
unit’s high pressure outlet.
Step 2 Insert the Vario spray wand
into the gun. Push in and turn clock-
wise to lock spray wand in place.
Step 3 Connect
garden hose to unit’s
water inlet.
Step 4 Connect garden
hose to the cold water
source and turn water on
completely.
Step 5 Trigger the gun to
eliminate trapped air, wait for a steady
flow of water to emerge
from the spray nozzle.
Step 6
Model K 1800 IB:
Slide the throttle control to the fast
position. Then push primer ball three
times. Wait 3 seconds between each
push.
Note: in cold weather push 5 times
NOTE: Engines controls shown may appear different.
You are now ready to
operate your Kärcher
Pressure Washer.
3
ASSEMBLY INSTRUCTIONS
Step 1
Slide the handle through the
accessory rack.
Step 3
Check oil level. Oil level should
always be between the “FULL” and “ADD”
marks on the dipstick. Be sure the machine is
level when checking the oil level. (Refer to the
engine’s operating manual for seasonal
grades.)
Step 4
Insert the detergent tray into one
of the slots of your choice and screw in the
fastener. Fill with the proper detergent for
your cleaning project.
Important! Do
not run the engine
with a high or low oil level as this can
cause engine damage. If you have fur-
ther questions regarding the engine,
please refer to the engine’s operating
manual included with the unit.
Step 5
Fill gas tank with unleaded
gasoline. Do not use leaded gasoline.
Step 2
Align the holes of the accessory
rack to the handle and fasten the four (4) screws.
K1800IB/2200IB Washer ManV2.2 9/25/02 6:03 PM Page 4