Specifications

ManualsBrandsBriggs & Stratton ManualsAutomobile Parts250000

151

152

153

154

155

156

157

158

159

160

NOTE: SPECIFICATION TABLES BEGIN ON PAGE 28 OF THIS SECTION.

Single & Dual Spring

Model Series 176400, 19B400, 19C400,

19E400, 19F400, 19G400, 192400, 196400,

226400, 250400, 256400

See Table No. 6, Specifications, Page 28, and place

governor spring in holes 1 through 12, Fig. 20, to attain

required RPM.

Generator Engines

Model Series 93400

Place governor spring in governor lever hole number 2

for 50 Cycle (3000 RPM) or hole number 3 for 60 Cycle

(3600 RPM) generators.

DO NOT USE HOLE LOCATIONS SHOWN IN TABLE

NO 4, SPECIFICATIONS, Page 28.

Generator Engines

Model Series 133400

Place governor spring in governor lever hole number 2

for 50 Cycle (3000 RPM) or hole number 4 for 60 Cycle

(3600 RPM) generators.

Fig. 20

DO NOT USE HOLE LOCATIONS SHOWN IN TABLE

NO. 5, SPECIFICATIONS, page 28.

Generator Engines

Model Series 176400, 19B400, 19C400,

19E400, 19F400, 19G400, 196400, 226400,

250400, 256400

Place governor spring in governor lever hole number 4

for 50 Cycle (3000 RPM) or hole number 8 for 60 Cycle

(3600 RPM) generators.

DO NOT USE HOLE LOCATIONS SHOWN IN TABLE

NO. 6, SPECIFICATIONS, page 28.

Static Governor Adjustment

Horizontal Crankshaft

1. Loosen screw holding governor lever to governor

crank.

2. Rotate throttle plate linkage from idle position to

wide open position. Note direction of rotation of the

governor arm attached to the throttle linkage.

3. Place and hold the linkage in high speed position.

4. While holding the linkage in this position, use an

appropriate tool to rotate the governor shaft until it

stops in the direction noted in step 2.

5. Tighten screw holding governor lever to governor

crank. Torque to 35 – 45 in. lbs. (3 – 5 Nm).

6. Before starting engine, manually actuate governor

linkage to check for binding.

Final Governor Adjustment

Adjust Top No Load Speed

Model Series 83400 (Generator)

Turn screw to 3750 RPM, Fig. 21, unless a load bank is

available to load engine to full generator rated output.

Then load generator to full rated output with load bank

and turn screw to obtain 3600 RPM.

Fig. 21