Specifications

5
17
NOTE: SPECIFICATION TABLES BEGIN ON PAGE 28 OF THIS SECTION.
Governed Idle (Non-Generator)
1. Turn carburetor idle speed adjusting screw to
obtain 1600 RPM while holding throttle lever
against screw.
2. Release throttle lever.
3. Align holes in control bracket and inside lever with
1/8” (3.18 mm) diameter rod. Governor speed
control lever of equipment should be in “IDLE”
position, Fig. 34.
4. Adjust if necessary. Bend spring tang to obtain
1750 RPM.
5. Remove 1/8” (3.18 mm) diameter rod.
B
Fig. 34
A
Generator Applications Only
Governor regulation to within two cycles of either 60 or
50 cycles can be obtained if the procedures indicated
below are followed:
1. Push speed adjusting nut in and up to release
spring tension on nut.
2. Start engine and pull out on speed adjusting nut to
maximum length of travel, Fig. 35.
Fig. 35
3. Set engine speed per Table No. 10, Specifica-
tions, Page 30 by bending governor tang, Fig. 36.
4. With engine still running, return speed adjusting
nut to slot, push in to compress spring and push
nut down into slot.
5. Then turn speed adjusting nut to obtain:
1600 RPM Top No Load for 1500 RPM 50 cycle
generator
1875 RPM Top No Load for 1800 RPM 60 cycle
generator
3150 RPM Top No Load for 3000 RPM 50 cycle
generator
3750 RPM Top No Load for 3600 RPM 60 cycle
generator
A
Fig. 36