Specifications

7
25
NOTE: SPECIFICATION TABLES BEGIN ON PAGE 41 OF THIS SECTION.
Assemble Starter Motor
Lightly lubricate bearings with #20 oil and reassemble
in the following manner.
1. Insert brush springs and brushes (1), Fig. 46, in
holders as far as possible, and hold them in this
position with brush retainers, Figs. 6, 46.
2. Slide motor housing over armature with the notch
toward commutator end cap.
3. Match notch in housing with boss on brush end
cap. Remove brush holders, if used, and rotate
armature to be sure brushes are making full
contact with commutator.
Fig. 46
1
4. Care should be used to prevent damage to
magnets in motor housing during assembly.
5. Assemble spacers (1) and drive head end bracket,
bearing shown – (2), aligning seam in housing with
drive end mounting bracket.
6. Assemble thru bolts and torque to 35 in. lbs. (4 Nm).
7. Armature end play should be .006” to .038” (.15 to
.97 mm) after assembly, Fig. 47.
Install starter on engine and torque mounting screws to
140 in. lbs. (16 Nm).
Fig. 47
2
1