Specifications

7
30
NOTE: SPECIFICATION TABLES BEGIN ON PAGE 41 OF THIS SECTION.
Starter Motor Drive, C-Ring Retainer Type
Disassemble
1. Remove C-ring retainer using Tool# 19436,
C-Ring Retainer Removal Tool, Fig. 57. Place
counterbored side of tool over retainer and align
drive pins with open end of C-ring. Place palm of
hand over tool. Push down on tool to compress
spring washer while turning screw clockwise.
Continue turning screw until C-ring retainer pops
off. Discard old C-ring.
WARNING
Flying objects can cause personal
injury or property damage.
• To prevent eye injury always wear eye
protection when removing c-ring retainer.
Fig. 57
2
1
2. Remove retainer (1), return spring (2), flat washer
(3), spring washer (4), pinion gear (5), and starter
clutch (6), Fig. 58.
The pinion gear should be inspected for damaged
teeth. If a sticking condition exists between the pinion
gear and the helix, correct before reassembly. The
parts may be washed in a solvent such as Stanisol or
Varsol. Do not lubricate helix except with dry silicone
spray. The gear, return spring, wave washer, flat
washer, retainer, retainer ring and clutch assembly are
available as service parts.
Fig. 58
6
5
2
4
1
3
Install Clutch
1. Place starter clutch on starter shaft, Fig. 59 A, and
rotate clutch until it drops into place, Fig. 59 B.
Fig. 59
A B