Specifications

7
32
NOTE: SPECIFICATION TABLES BEGIN ON PAGE 41 OF THIS SECTION.
Starter Motor Drive, Roll Pin Retainer Style
Disassemble
1. Place retainer (2) in “V” block (1) as shown in
Fig. 63.
2. Drive the roll pin out with a hammer and 1/8” (3.0
mm) diameter punch (3) to remove the retainer.
Fig. 63
2
1
3
NOTE:Some starter drive assemblies utilize a
gear return spring. Two styles of returns
have been used. Current style, Fig. 64 and
early style, Fig. 65.
The current style is removed after removing the roll pin
(1). The early style is protected by a plastic cap over
the drive assembly. Carefully remove the plastic cap
from the cup using two screwdrivers, Fig. 65.
The pinion gear should be inspected for damaged teeth.
If a sticking condition exists between the pinion gear
and the helix, correct before reassembly. The parts may
be washed in a solvent such as Stanisol or Varsol.
Do not lubricate helix except with dry silicone spray.
Fig. 64
1
Fig. 65