Specifications

NOTE: SPECIFICATION TABLES BEGIN ON PAGE 15 OF THIS SECTION.

Install Module on Ignition Armature

Install the module with the retainer on the side of the

armature with small rivet ends (1), Fig. 14.

Ignition armature ground wire (2), Fig. 14.

Ignition armature primary wire (3), Fig. 14.

Fig. 14

Install Stop Switch and

Ignition Armature Primary Wire

1. Remove all insulating material from ends of wires

to ensure good contact.

2. Use a 3/16 inch (4.7 mm) diameter pin punch (5) or

a condenser from point set Part #294628 to

compress wire retainer spring and insert stop

switch and ignition armature primary wire under

hook of wire retainer, Fig. 15. Module ground lead

(1), module wire (2), coil primary wire (3), wire to

stop switch (ground wire) (4).

Fig. 15

3. Twist wires together and solder with 60/40 rosin

core solder. DO NOT OVERHEAT WIRES OR

MODULE BODY.

4. Install wires in module retainer.

5. Seal wires to ignition armature (1) with Permatex

No. 2 or similar sealer to prevent wires from

vibrating and breaking, Fig. 16.

Fig. 16

Timing Magnetronr Ignition

Timing of Magnetron ignition is solely controlled by

the flywheel key on all Model Series except 230000,

240000 and 320000.

Timing Magnetronr Ignition Armature

Model Series 230000, 240000, 320000

Position adjustable ignition armature bracket (1) so

mounting screws are centered (2) in ignition armature

bracket slots (gasoline engines), Fig. 17. Ignition

armature with Magnetron module assembly.

Fig. 17