Specifications

2
NOTE: SPECIFICATION TABLES BEGIN ON PAGE 15 OF THIS SECTION.
8
Timing Magnetronr Ignition Armature
Model Series 32K400
Position ignition armature bracket so mounting screws
are to the far left in the ignition armature bracket slots.
Tighten screws.
INSTALL IGNITION ARMATURES
Pneumatic (Fig. 18) and Mechanical (Fig. 19)
1. Install ignition armature and air vane or air guide
(3), when used. The mounting holes of the ignition
armature are slotted.
2. Push ignition armature away from flywheel (4) as
far as possible and tighten one mounting screw (1).
Ignition armature coil (2).
Fig. 18
1
2
3
4
Fig. 19
1
4
Adjust Ignition Armature Air Gap
1. Ignition armature air gaps are found in
Table No. 1, page 15.
2. With ignition armature away from flywheel as far
as possible and one screw (2) tightened, turn
flywheel so magnets (1) are away from armature
legs.
3. Place the proper thickness gauge (3) between rim
of flywheel and laminations of the ignition
armature.
4. While holding gauge, turn flywheel until magnets
are directly under legs.
5. Loosen the screw holding armature and let
magnets pull ignition armature down against
flywheel.
6. Tighten both mounting screws.
7. Rotate flywheel until gauge is free (4), Fig. 20.
STOP SWITCH IDENTIFICATION
Stationary (2), rotary (3), toggle (1), and key stop (4)
switches are used to meet various equipment needs,
Fig. 21.
1
2
3
4
Fig. 20
1
2
3
1
43
2
Fig. 21