Specifications

NOTE: SPECIFICATION TABLES BEGIN ON PAGE 24 OF THIS SECTION.

12. Torque cover screws (8) to 190 in. lbs. (21 Nm),

Fig. 38.

Fig. 38

Fill Gear Case with Lubricant (Fig. 39)

1. Install drain plug (2) in bottom of gear case (if

equipped). Torque to 65 in. lbs. (7 Nm).

2. Remove oil level plug (3).

3. Fill gear case just to the point of overflowing at the

lower hole with the proper oil. See Section 8,

Lubrication.

4. Install oil level plug in lower hole (if equipped).

Torque to 90 in. lbs. (10 Nm).

5. Install vent plug (1) in top hole, (if equipped).

Torque to 40 in. lbs. (5 Nm).

NOTE:On Model Series 230000, 240000, the

gear reduction and the engine use the

same oil supply. After initial fill, start and

run engine briefly. Then stop engine,

recheck oil level and add oil as required to

bring level to full.

Fig. 39

Model Series 230000

Clockwise PTO Rotation

Drain and Disassemble

Note position of gear reduction case on engine, Fig.

36.

1. Loosen all the cover cap screws (1) one to two

turns.

2. Break cover (2) loose from case. Drain oil.

3. After gear case is drained, remove cap screws and

cover, Fig. 40.

Fig. 40