Specifications

2
NOTE: SPECIFICATION TABLES BEGIN ON PAGE 15 OF THIS SECTION.
9
Stationary Stop Switch
Location
Stationary stop switches are located on fuel tank
brackets, governor control brackets, cylinder head
brackets, System 2 and System 4 band brake
control brackets, and brake shoe on Model Series
100700, 120000. Typical installation, Fig. 22.
Stop switch assembly (1), slot in bracket (2), insert stop
switch into slot (3), push down until it snaps into place
(4), stop switch in position (5). Reverse steps to
remove.
Fig. 22
1
2
3
4
5
Mechanical Check, Typical Control
RUN Position
Move control lever away from stop switch using safety
control (1) shown on handle (2) in Fig. 23, or by moving
control lever (3) at engine in direction shown in Fig. 24.
Stop switch (4)
Control bracket (5)
Fig. 23
1
2
Fig. 24
3
4
5
1. For STOP position, release control completely.
Control lever (1) at engine must contact (2) stop
switch (3) at tang (5) shown in Fig. 25.
Control bracket (4)
Ground wire (6)
Direction of movement (7)
Fig. 25
1
3
5
2
4
6
7