Specifications

3
NOTE: SPECIFICATION TABLES BEGIN ON PAGE 63 OF THIS SECTION.
21
Assemble Carburetor to Fuel Tank Pulsa-Jet
(except Model Series 113900, Type #2999),
and Vacu-Jet (except Choke-A-Matic
)
1. Place “O”-ring (1) in groove in throttle bore, (Vacu-
Jet) Fig. 42. Cross section (2), new “O” ring (3),
Fig. 42.
Fig. 42
1
2
3
2. Holding carburetor body upside down, place
diaphragm on body while guiding choke link thru
link hole for link. Be sure that pump spring and cap
(1) are in fuel pump well, (Pulsa-Jet) Fig. 43.
Fig. 43
1
3. Lower tank down onto carburetor, while guiding
choke spring into spring well, Pulsa-Jet shown,
Fig. 44.
4. While holding carburetor and body together, turn
assembly right side up.
5. Thread carburetor mounting screws into tank top
about two turns. DO NOT TIGHTEN.
Fig. 44