Specifications

3
NOTE: SPECIFICATION TABLES BEGIN ON PAGE 63 OF THIS SECTION.
45
LMT Models
(Plastic Choke Shaft and Plate)
1. Insert spring inside large foam seal and slide seal
and spring onto choke shaft with straight end of
spring up toward choke shaft lever (3).
2. Insert choke shaft into carburetor body until hook
of spring hooks on spring anchor (1).
3. Lift choke shaft and lever up slightly and turn
counterclockwise until stop on lever (2) clears
spring anchor (1) and push shaft down, Fig. 113.
4. Insert choke plate (4) into choke shaft and lever
with dimples (5) toward fuel inlet (6) side of
carburetor. Dimples help to hold and align choke
plate on shaft.
Fig. 113
3
2
1
4
5
6
(Metal Choke Shaft and Plate)
1. Install foam seal and return spring on choke shaft
hooking small hook (1) in notch on choke lever,
Fig. 114, inset.
2. Insert choke shaft assembly into carburetor body
and engage large end of return spring on boss.
3. If carburetor has spring detent, guide detent spring
(2) into slot on choke shaft lever (4).
4. Place choke plate (5) on shaft with single notch on
edge towards fuel inlet. Two half moon dimples will
help to position valve on shaft.
Fig. 114
3
2
1
4
5
6
Install Throttle Shaft
1. Install throttle shaft seal (2) with sealing lip down in
carburetor body until top of seal is flush with top of
carburetor (LMT), Fig. 115.
2. Install throttle shaft and small foam washer (1).
3. Turn shaft until flat is facing out.
4. Lay throttle plate (3) on shaft with numbers (4)
facing out and install screw (LMS).
5. Lay throttle plate on shaft with numbers (4) toward
idle mixture screw and dimples facing in, resting
on edge of shaft. Install two screws (LMT shown),
Fig. 115.
Fig. 115
3
2
1
4
5