Operating instructions

44 agria Multi-Purpose Machine 400E/400K
Operation
W
Check safety circuit function
- only operate the machine if the
safety circuit is working.
Wear individual protec-
tive ear plugs and solid
shoes.
l Couple the attachment.
l Set the correct ground speed for the
attachment.
l Set drive-wheels to position “drive”.
l Switch on wheel drive with hand lever
(E/11 or G/11).
l For pto-driven attachments: move pto
lever (A/1 or H/6) to “I”.
l Slightly pull on hand clutch lever (E/4
or G/4), unlock pawl (E/5 or G/5), release
slowly and press the throttle. The pto-
driven attachment starts moving and the
multi-purpose machine travels forward.
Reverse
l Move speed control lever to
NEUTRAL/IDLE POSITION.
l Pull hand clutch lever (E/4 or G/4) to
middle position and wait until the machine
stops moving forward.
l Pull hand clutch lever all the way up
and press the trottle at the same time.
W
If cleaning becomes neces-
sary during operation, cut out
the engine and remove spark plug con-
nector for safety reasons.
End of operation:
l Switch off wheel-drive. To do this,
pull hand lever for wheel drive (E/11
or G/11) and lock pawl.
l Pull hand-clutch lever (E/4 or G/4)
and lock pawl.
l For pto-driven attachments: Move
the pto-lever (A/1 or H/6) to position
“0”.
l Turn off the engine.
W
Immediately re-install any
guards on the attachment
(e.g. knife strip on the cutterbar).
Danger zone
W
Keep out of the machine’s
danger zone during starts
and operation.
4. Commissioning and Operation
Mowing: danger zone
Hoeing: danger zone
5
4227