Operating instructions

agria Multi-Purpose Machine 400E/400K 49
Removing
Carbon Deposits
After every 100 hours of operation take
off cylinder head and remove carbon
deposits on cylinder, cylinder head, pis-
ton crown, and valves and renew gas-
ket.
è - Serviceç
Cylinder Head Screws
After the first 5 operating hours re-
tighten cylinder head screws at 16 Nm
(1.6 kpm).
Speed Control
Engine speed controls must be adjusted
correctly to start, operate and switch off
the engine at correct speed rates.
è - Serviceç
Carburetor Settings
Small differences in fuel, temperature,
height or strain can require slight adjust-
ment of the carburetor. Only let the en-
gine run with air filter and air filter cover
fitted.
è - Serviceç
5. Maintenance
Battery (Type 400K)
Power is used from the battery when
starting by using the electrical start
equipment. This causes it to discharge.
The generator partially re-charges it
during operation.
Use a standard charger with 12V and a
maximum charge of 0.6 A for re-charging.
If the machine or trailer will not be used
for a longer period, the battery must be
kept fully charged with a current of 0.06A
and checked every 4 weeks and re-
charged, if necessary. Before recharge,
disconnect negative pole.
I
The battery manufacturer's
operating instructions are the
standard for the operation of the bat-
tery and its care and maintenance.
Never leave
battery in uncharged state! Note
manufacturer’s instructions. Avoid
sparking and open flames near bat-
teries - threat of an explosion!
Careful when handling battery acid –
etching!
Only use specified fuses. If fuses are
too strong, the electric system will be
destroyed – danger of fire!
Avoid short circuits.
I
The battery contains poisonous
substances and heavy metals
and constitutes hazardous waste.
5