Operator`s manual

5. Place accessory tray (A) over holes (C) on handle

(viewing from front of unit). Push the tree clips (B) into

the holes until they sit flat against the accessory tray.

6. Insert “L” bolt (D) through hole just below billboard on

right side of handle (viewing from front of unit). Hold

“L” bolt in place and attach a plastic knob (E) from

inside of unit. Tighten by hand.

7. Insert supplied accessories in spaces provided in

accessory tray. See How to Use Accessory Tray.

Attach Detergent Siphon Hose to Pump

Attach detergent siphon hose (F) to barbed hose fitting (G)

on pump.

Add Engine Oil and Fuel

• Place pressure washer on a level surface.

• Refer to engine operator’s manual and follow oil and

fuel recommendations and instructions.

NOTE: Check oil often during engine break–in. Refer to

engine operator’s manual for recommendations.

Connect Hose and Water Supply to Pump

NOTE: Remove and discard the shipping caps from the

pump’s high pressure outlet and water inlet before attaching

hoses.

1. Uncoil high pressure hose and attach one end of hose

to base of spray gun. Tighten by hand.

NOTICE

Any attempt to crank or start the engine before it has been

properly filled with the recommended oil will result in

equipment failure.

• Refer to engine manual for oil and fuel fill information.

• Damage to equipment resulting from failure to follow this

instruction will void warranty.

NOTICE

DO NOT run the pump without the water supply connected

and turned on.

• Damage to equipment resulting from failure to follow this

instruction will void warranty.

WARNING

The high pressure stream of water that this

equipment produces can cut through skin and its

underlying tissues, leading to serious injury and

possible amputation.

• NEVER connect high pressure hose to nozzle extension.

• Keep high pressure hose connected to pump and spray gun

while system is pressurized.

• Always be certain spray gun, nozzles and accessories are

correctly attached.