User Manual

10
connection is established. If the address shows as all 0s no
connection is present.
Profiles
A list of profiles containing configuration settings for the
Wireless LAN network interface is provided here. The
settings in use will be shown as Currently Active. Other
available profiles will have a Make Active button next to the
profile name that allows you to change the settings used by
the Wireless LAN interface and restart the network.
Bluetooth Adapter
The device can make a connection to a Bluetooth enabled PC. A zero
configuration IP (ZCIP) address will be used. The Bluetooth and WLAN network
interfaces cannot be used concurrently. Enabling one will force the other to be
disabled.
Enable Button
Enable the interface when it has been previously disabled
Disable Button
Disable the interface, preventing any traffic across the
interface
Restart Button
This button can be used to restart the Bluetooth network
interface.
Status
Shows the current state of the interface, Active, Started, and
Disabled
IP Address
The IP address currently assigned to the Bluetooth interface
via ZCIP.
USB Adapter
The USB network interface is provided via the USB connector on the device. The
connector can be found on the faceplate just below the antenna. The USB cable
provided with the device when purchased should be used. Connect the mini-
connector end to the device and the other end to a Windows PC which has the
Bright Star Engineering Ethernet Gadget drivers installed. A DHCP server is
provided on the device to assign an IP address to the PC when connected over
the USB interface. Refer to the TCP/IP over USB web page description further
on in this document for more information.
Restart Button
This button can be used to restart the USB network interface
should a problem occur
Status
Shows the current state of the interface, Active, Started, and
Disabled
IP Address
The IP address currently assigned to the Bluetooth interface
via static assignment.