Installation Guide

INSTALLATION GUIDE
For further assistance, contact the support team at [e-mail]
DOCUMENT DATE: 05/27/21
B4002.1020 - RED KOMODO KIPPERTIE RF SUPPORT
The RF mount on the Komodo is a sprung mount
system, and relies on small springs inside the
mount to pull the adapter into the right place.
If the adapter support is installed incorrectly, it can
result in the lens adapter being pushed or tilted in
the wrong direction, which can result in focus and
other optical issues.
The following installation sequence must be
followed in order to ensure that the adapter is
supported correctly on the camera body.
You will need to use a 2.5mm Hex Key.
Step 1 - Prepare the RED Komodo with the required plates. Ensure all the plates are secured and tight.
Step 2 - Install the Kippertie adapter into the camera, allowing it to twist onto the camera body and
click into place.
Step 3 - Align the suppport to the Kippertie adapter, ensuring that the arm is on the left side. Using
the 2.5mm hex key, connect the two M3 captive screws (B) into the mounting holes on the
bottom of the adapter. Do not tighten fully at this point.
Step 4 - Insert & secure the mounting screws (A) on the side & top plate in a criss-cross patern, while
also tightening up the bottom captive screws (B).
Step 5 - To remove the support. First, loosen the mounting screws (A) before loosening the two
captive screws (B) on the bottom of the adapter.
A
A
A
B
B
A - Mount Screw - M3x10mm - 2.5mm Hex
B - Captive Screw - M3 - 2.5mm Hex